1. Киришүү
This manual provides essential information for the safe and efficient use of your WAC Lighting EN-1260-P-AR-WT Electronic Transformer. This Class 2 plug-in electronic transformer converts 120V AC input to 12V AC output, supporting a maximum load of 60W. It is designed for use with low voltage fixtures, such as under cabinet and display luminaires, and features soft start, short circuit, and overload protection.
Image 1.1: WAC Lighting EN-1260-P-AR-WT Electronic Transformer with cord and plug.
2. Коопсуздук маалыматы
Please read and understand all instructions before installation and use. Failure to follow these instructions may result in electric shock, fire, or other hazards.
- Ensure power is disconnected at the circuit breaker before installing or servicing the transformer.
- This product is intended for indoor use in damp locations, as specified by UL & CUL listings.
- Do not exceed the maximum load capacity of 60W. A minimum load of 1W is required for low load LED systems.
- Dimmers should always be installed on the primary (120V AC) side of the transformer. Use only electronic low voltage dimmers for smooth and continuous dimming.
- 65-сунуш. Эскертүү: Бул продукт Калифорния штатына рак жана тубаса кемтиктерди же башка репродуктивдик зыян келтирерин белгилүү болгон химиялык заттарды камтышы мүмкүн. Көбүрөөк маалымат алуу үчүн, бул жерге кириңиз www.P65Warnings.ca.gov.
3. Продукциянын өзгөчөлүктөрү
- Soft start feature to extend lamp life by delaying inrush current.
- Integrated short circuit and overload protection.
- 1W minimum load for compatibility with low load LED systems.
- Built-in on/off toggle switch at the base.
- Includes a 72-inch (6-foot) detachable cord with an open splice for wiring.
- Designed for smooth and continuous dimming with electronic low voltage диммерлер.
- UL & CUL listed Class 2 for damp жерлер.
- Ак түстөгү жасалга.
4. Орнотуу жана орнотуу
This transformer is a plug-in unit designed for straightforward installation. Ensure all connections are secure and comply with local electrical codes.
- Зымдарды даярдоо: The transformer comes with a 72-inch detachable cord with an open splice. Connect the open splice wires to your low voltage fixtures (e.g., under cabinet lighting). Ensure proper polarity if required by your fixtures.
- Монтаждоо: The transformer is a protruding type. Ensure it is placed in a location that allows for adequate ventilation and is protected from direct moisture, even though it is rated for damp жерлер.
- Connect Fixtures: Wire your 12V AC low voltage fixtures to the output side of the transformer. Ensure the total wattage of all connected fixtures does not exceed 60W and meets the minimum 1W load requirement.
- Кубат туташуу: Once all low voltage connections are made and secured, plug the transformer into a standard 120V AC wall outlet.
- Dimmer Installation (Optional): If using a dimmer, install an electronic low voltage dimmer on the 120V AC input side of the circuit, before the transformer. Refer to the dimmer's instructions for installation.
5. Иштөө нускамалары
The WAC Lighting EN-1260-P-AR-WT transformer is simple to operate:
- Күйгүзүү/өчүрүү: Use the toggle switch located at the base of the transformer to turn the connected lighting system on or off.
- алсыздатуу: If an electronic low voltage dimmer is installed on the input circuit, use the dimmer control to adjust the light output of the connected fixtures.
6. Техникалык тейлөө
The WAC Lighting EN-1260-P-AR-WT Electronic Transformer requires minimal maintenance.
- Тазалоо: Disconnect power before cleaning. Wipe the exterior of the transformer with a soft, dry cloth. Do not use abrasive cleaners or solvents.
- Текшерүү: Periodically inspect the cord and connections for any signs of damage or wear. If damage is found, discontinue use and replace the unit.
7. Кыйынчылыктарды
If you experience issues with your transformer, refer to the following table:
| Көйгөй | Мүмкүн себеп | Чечим |
|---|---|---|
| Жарыктар күйбөйт. | No power to outlet; Transformer switch off; Loose connections; Overload protection activated; Faulty fixture. | Check outlet power; Ensure transformer switch is ON; Verify all wiring connections; Reduce total load; Test fixtures individually. |
| Жарыктар ыраатсыз жытылып же күңүрт. | Incompatible dimmer; Load too low; Loose connections. | Ensure an electronic low voltage dimmer is used; Verify total load is above 1W; Check all wiring. |
| Transformer is hot to the touch. | Ашыкча жүктөө; Жетишсиз желдетүү. | Reduce total connected load; Ensure transformer has adequate airflow. |
8. Техникалык шарттар
| Спецификация | Деталь |
|---|---|
| Модель номери | EN-1260-P-AR-WT |
| Киргизүү көлөмүtage | 120V AC |
| Output Voltage | 12V AC |
| Максималдуу жүк | 60 Вт |
| Минималдуу жүктөө | 1W (for LED systems) |
| Power Source | Электр зымдары |
| Монтаж түрү | Чыккан |
| Сертификаттар | UL & CUL Listed Class 2 |
| Элемент Салмагы | 7.2 унция |
| UPC | 790576094717 |
| Өлчөмдөрү (L x W x Y) | 2 3/4" x 1 5/8" x 1 3/4" |
Image 8.1: Dimensional drawing of the WAC Lighting EN-1260-P-AR-WT Electronic Transformer.
9. Кепилдик маалыматы
This WAC Lighting Electronic Transformer is covered by a Five (5) year manufacturer limited warranty. For specific terms and conditions, please refer to the warranty documentation included with your purchase or visit the official WAC Lighting webсайт.
10. Колдоо жана байланыш
For technical assistance, troubleshooting beyond this manual, or warranty claims, please contact WAC Lighting customer support directly. Refer to the packaging or the official WAC Lighting webакыркы байланыш маалыматы үчүн сайт.
WAC Lighting Official Webсайт: www.waclighting.com