Clover B14A Hot and Cold Bottled Water Dispenser User Manual

1. Киришүү

The Clover B14A Hot and Cold Bottled Water Dispenser provides convenient access to refreshing chilled drinking water and piping hot water. Designed for home or office use, this dispenser features hygienic stainless steel tanks and an efficient cooling and heating system. Please read this manual thoroughly before operation to ensure safe and optimal performance.

2. Коопсуздук маалыматы

• Электр коопсуздугу: This appliance operates on 110-120 volts, 50-60 Hz. Ensure the power outlet is properly grounded. Do not use with damaged cords or plugs.
• Ысык суу коопсуздугу: The hot water temperature reaches approximately 185°F (85°C). Exercise extreme caution when dispensing hot water to prevent burns. A safety switch is provided for the hot water dispenser.
• Балдардын коопсуздугу: Always engage the hot water safety switch when children are present to prevent accidental dispensing of hot water.
• Жайгашкан жери: Place the dispenser on a flat, stable surface away from direct sunlight, heat sources, and areas with high humidity. Ensure adequate ventilation around the unit.
• Суу Бөтөлкө: Use only standard 5-gallon (18.9-liter) water bottles.
• Тейлөө: Тазалоодон же техникалык тейлөөдөн мурун блокту электр розеткасынан сууруп алыңыз.

3. Орнотуу

1. Пакеттен чыгаруу: Диспенсерди таңгагынан этияттык менен чыгарыңыз. Кандайдыр бир бузулууларды текшериңиз.
2. Жайгашкан жери: Position the dispenser on a level, sturdy surface. Allow at least 4 inches (10 cm) of clearance from walls for proper ventilation.
3. Тамчы салгычты орнотуу: Insert the concealed, lift-out drip tray into its designated slot below the spigots.
4. Алгачкы тазалоо: Биринчи колдонуудан мурун сыртын жумшак, гamp кездеме.
5. Суу бөтөлкөсүн орнотуу: Remove the protective seal from a new 5-gallon water bottle. Lift the bottle and quickly invert it, placing it firmly onto the bottle support on top of the dispenser. Ensure the bottle is seated correctly to prevent leaks.
6. Аюу системасы: Before plugging in, dispense at least 1 liter (approximately 4 cups) of water from both the hot and cold spigots to ensure the tanks are filled and to flush any air from the system.
7. Плагин: Кубат шнурун жерге туташтырылган 110-120 В электр розеткасына сайыңыз.

1-сүрөт: Толук view of the Clover B14A water dispenser with a 5-gallon bottle.

4. Иштөө нускамалары

1. Күйгүзүү: Once plugged in, the dispenser will begin cooling and heating the water. Allow approximately 15-30 minutes for the water to reach desired temperatures.
2. Муздак суу берүү: Place your cup under the cold water spigot (typically blue). Push the lever to dispense cold water. Release the lever to stop.
3. Ысык сууну берүү: Place your cup under the hot water spigot (typically red). To dispense hot water, first push the safety switch (often a red button or lever) and then push the main lever. Release both to stop.
4. Ысык суу өчүргүч: The hot water function can be turned on or off using the switch located on the back of the unit. Turning it off will prevent the water from heating, saving energy and acting as an additional safety measure.
5. Adjusting Cold Water Temperature: The cold water temperature can be adjusted via a thermostat control, usually located on the back of the unit. It allows for a range of 35.6°F to 53.6°F (2°C to 12°C).

Figure 2: Detail of the hot (red) and cold (blue) water spigots with the hot water safety switch.

5. Техникалык тейлөө

• Тамчылатуучу лотокту тазалоо: The drip tray is removable for easy cleaning. Periodically empty and wash the tray with mild soap and water.
• Тышкы тазалоо: Сырткы беттерин жумшак менен сүртүңүз, гamp кездеме. Абразивдүү тазалагычтарды же эриткичтерди колдонбоңуз.
• Тазалоо: Over time, mineral deposits may accumulate in the hot water tank. Consult the manufacturer's website or customer support for recommended descaling procedures.
• Суу багын тазалоо: For thorough cleaning of the internal water tanks, it is recommended to contact a qualified service technician.

6. Кыйынчылыктарды

• Суу бөлүштүрүү жок: Ensure the water bottle is properly seated and not empty. Check if the unit is plugged in and powered on.
• Ысык суу жок: Verify the hot water switch on the back of the unit is in the 'ON' position. Check if the thermal reset button (often a small red button on the back) needs to be pressed.
• No Cold Water: Ensure the unit is plugged in and the cold water thermostat is set to a desired temperature.
• агып жатат: Check the water bottle for cracks or improper seating. Ensure the drip tray is correctly installed.
• адаттан тыш ызы-чуу: The unit is designed for quiet operation. If unusual or excessive noise occurs, ensure the unit is on a level surface and not vibrating against a wall. If noise persists, contact customer support.

7. Техникалык шарттар

• Модел: B14A
• Өлчөмдөрү (D x W x Y): 12.3" x 12.7" x 37.9" (31.2 см x 32.3 см x 96.3 см)
• Салмагы: 32 фунт (14.5 кг)
• Түсү: Black with Steel side panels
• Тtage: 110-120V
• Жыштыгы: 50-60 Гц
• Ысык суунун температурасы: Approximately 185°F (85°C) (non-adjustable)
• Муздак суунун температурасы: 35.6°F - 53.6°F (2°C - 12°C) (adjustable)
• Compatible Bottle Sizes: 5 галлон (18.9 литр)
• Курулуш материалдары: Дат баспас болоттон жасалган, пластик
• Сертификаттар: CE, NSF, UL, Energy Star Rated
• Тамчылатма табак: Concealed, lift-out design, high impact, durable ABS. Removable, anti-splash grid.

8. Кепилдик жана колдоо

The Clover B14A Hot and Cold Bottled Water Dispenser comes with a 1 жылдык чектелген өндүрүүчүнүн кепилдиги. For warranty claims, technical assistance, or further inquiries, please contact Clover customer support. Keep your purchase receipt as proof of purchase.