ADC ADTEMP II Digital Thermometer Model 413B-00 User Manual

1. Киришүү

Thank you for choosing the ADC ADTEMP II Digital Thermometer, Model 413B-00. This compact and reliable thermometer is designed for accurate temperature measurement. Please read this manual thoroughly before use to ensure proper operation, maintenance, and to achieve the most accurate results.

2. Продукт бүтүп калдыview

The image shows the ADC ADTEMP II Digital Thermometer, a white, pen-shaped device with a digital display showing '98.6 °F'. It is accompanied by its clear plastic protective case, which has the 'ADC AMERICAN DIAGNOSTIC CORPORATION' logo printed on it. The thermometer features a blue cap at the end opposite the probe.

Негизги өзгөчөлүктөрү:

• Accurate digital temperature readings.
• Compact size, under 5 inches long, for easy handling and storage.
• Auto-off function to conserve battery life.
• Clear plastic case included for sanitary storage.
• Measurement range: 90°F - 109.9°F (32°C - 43.9°C).

Эмне камтылган:

• ADC ADTEMP II Digital Thermometer
• Protective scabbard carry case

3. Орнотуу жана даярдоо

1. Аппаратты текшерүү: Before first use, carefully inspect the thermometer for any damage. Do not use if damaged.
2. Clean the Thermometer: Before and after each use, clean the thermometer probe as described in the "Maintenance and Cleaning" section.
3. Күйгүзүү: Press the power button (usually located near the display) to turn on the thermometer. A short beep will sound, and the display will show all segments briefly, followed by the last measured temperature or "Lo" if the ambient temperature is below 90°F (32°C).
4. Select Measurement Unit (if applicable): Some models allow switching between Fahrenheit (°F) and Celsius (°C). Refer to the device's specific instructions for this function, usually by holding the power button during startup.

4. Иштөө нускамалары

The ADTEMP II thermometer can be used for oral, rectal, or axillary (underarm) temperature measurements. Always ensure the probe is clean before use.

4.1 Oral Measurement (Recommended for Adults and Older Children)

1. Place the probe tip under the tongue as close to the heat pocket as possible.
2. Close your mouth and hold the thermometer in place with your lips and fingers. Avoid biting the thermometer.
3. Hold the thermometer until a series of beeps indicates the measurement is complete (approximately 60 seconds).
4. Read the temperature displayed.

4.2 Rectal Measurement (Recommended for Infants and Young Children)

1. Apply a water-soluble lubricant to the probe tip.
2. Gently insert the probe tip no more than 1/2 inch (1.3 cm) into the rectum. Do not force the thermometer.
3. Hold the thermometer in place until a series of beeps indicates the measurement is complete (approximately 60 seconds).
4. Read the temperature displayed.

4.3 Axillary (Underarm) Measurement (Less Accurate, Use as a Screening Method)

1. Зонддун учун колтуктун ортосуна коюңуз.
2. Ensure the arm is pressed firmly against the body to hold the thermometer in place.
3. Hold the thermometer until a series of beeps indicates the measurement is complete (approximately 5-10 minutes). Note: Axillary measurements take longer and are generally less accurate than oral or rectal methods.
4. Read the temperature displayed.

4.4 Өлчөөдөн кийин

• Turn off the thermometer by pressing the power button, or it will automatically shut off after approximately 10 minutes of inactivity to conserve battery.
• Clean the thermometer as per the "Maintenance and Cleaning" section.
• Термометрди коргоочу корпусунда сактаңыз.

5. Техникалык тейлөө жана тазалоо

5.1 Термометрди тазалоо

It is crucial to clean and disinfect the thermometer before and after each use to prevent cross-contamination.

1. Wipe the probe tip and shaft with a soft cloth dampened with 70% isopropyl alcohol or a mild soap and water solution.
2. Rinse the probe tip with cool water (do not immerse the entire thermometer).
3. Таза, жумшак чүпүрөк менен кылдат кургатыңыз.
4. Do not use harsh detergents, abrasive cleaners, or immerse the entire thermometer in water or cleaning solutions.

5.2 Батареяны алмаштыруу

The ADTEMP II thermometer uses a button cell battery. When the battery symbol appears on the display, it's time to replace the battery.

1. Locate the battery compartment cover, usually at the end opposite the probe.
2. Carefully remove the cover (a small screwdriver may be needed).
3. Remove the old battery and insert a new one of the same type (e.g., LR41 or SR41), ensuring correct polarity (+/-).
4. Батарея бөлүкчөсүнүн капкагын бекем орнотуңуз.
5. Эски батареяларды жергиликтүү эрежелерге ылайык жок кылыңыз.

5.3 Сактоо

• Колдонулбаган учурда термометрди коргоочу кутучасында сактаңыз.
• Салкын, кургак жерде, түз күндүн нурунан жана экстремалдык температурадан алыс сактаңыз.
• Балдар жетпеген жерде сактаңыз.

6. Кыйынчылыктарды

7. Техникалык шарттар

• Модел: 413B-00
• Өлчөө диапазону: 90°F - 109.9°F (32°C - 43.9°C)
• Дисплей түрү: Санарип
• Кубат булагы: Battery Powered (Button Cell)
• Автоматтык түрдө өчүрүү: Ооба, батареянын иштөө мөөнөтүн үнөмдөө үчүн
• Камтылган компоненттер: Scabbard carry case
• Материал: Пластик
• Түсү: Ак
• Өлчөмдөрү: Болжол менен 4.69 x 3.03 x 0.71 дюйм (пакеттелген)
• Салмагы: Approximately 0.01 ounces (packaged)
• Өндүрүүчү: ADC (American Diagnostic Corporation)

8. Кепилдик жана колдоо

ADC (American Diagnostic Corporation) products are manufactured to high standards. For specific warranty information, please refer to the warranty card included with your product or visit the official ADC website. For technical support, replacement parts, or service inquiries, please contact ADC customer service directly.

Байланыш маалыматы: Please refer to the packaging or the official ADC webакыркы байланыш маалыматы үчүн сайт.