DIRECTV RC66RX IR/RF Remote Control User Manual

Introduction

This manual provides instructions for the DIRECTV RC66RX IR/RF Remote Control. This remote is designed to operate most DirecTV receivers in both Infrared (IR) and Radio Frequency (RF) modes. The RF feature allows control of the receiver without direct line-of-sight. It is compatible with various DirecTV receiver models including R16, R22, H21, H22, H23, H24, HR21, HR22, HR23, HR24, HR34, and C31. Two AA batteries are included with the remote for immediate use.

Figure 1: Two DIRECTV RC66RX Remote Controls with Batteries

Жайгашуу

1. Батареяны орнотуу

1. Пульттун артындагы батарея бөлүкчөсүнүн капкагын табыңыз.
2. Бөлүмдү ачуу үчүн капкакты ылдый карай жылдырыңыз.
3. Эки AA батарейкасын салып, оң (+) жана терс (-) терминалдары бөлүмдүн ичиндеги индикаторлорго дал келгенин текшериңиз.
4. Батарея бөлүкчөсүнүн капкагын бекем чыккыча ордуна жылдырыңыз.

Figure 2: Battery Compartment of the RC66RX Remote

2. Programming for DirecTV Receiver

The RC66RX remote is typically pre-programmed to control your DirecTV receiver. If it does not respond, ensure the remote is set to the correct mode (usually 'DIRECTV' or 'SAT' if applicable, though this model primarily functions for DirecTV). For RF mode, your receiver must be compatible (R16, R22, H21, H22, H23, H24, HR21, HR22, HR23, HR24, HR34, C31). Refer to your DirecTV receiver's manual for specific RF pairing instructions if needed.

3. Programming for TV and Other Devices (IR Mode)

To control your television or other devices (e.g., AV receiver) with the RC66RX remote, you will need to program it using IR codes. This allows the remote to control functions like TV power, volume, and input.

1. Locate the mode switch at the top of the remote. Slide it to the 'TV' position.
2. Press and hold the 'MUTE' and 'SELECT' buttons simultaneously until the green light at the top of the remote blinks twice.
3. Enter the 5-digit programming code for your TV brand. You can find these codes in your DirecTV receiver's user manual or on the DirecTV support webсайт.
4. Point the remote at your TV and press the 'PWR' button. If the TV turns off, the code is correct.
5. If the TV does not turn off, repeat steps 2-4 with the next code for your TV brand.
6. Once the TV is programmed, slide the mode switch back to the 'DIRECTV' position to control your receiver.

Figure 3: Top Section of the RC66RX Remote with Mode Switch

Иштөө нускамалары

The DIRECTV RC66RX remote control features a comprehensive layout for easy navigation and control of your entertainment system.

Figure 4: Full Button Layout of the RC66RX Remote

Негизги баскыч функциялары:

• TV INPUT: Телевизоруңуздагы жеткиликтүү видео киргизүүлөр аркылуу айланыңыз.
• PWR (кубат): Turns the DirecTV receiver on or off.
• ON/OFF (&TV Power): Turns the programmed television on or off.
• ФОРМАТ: Экрандын кадр катышын өзгөртөт.
• Ойнотууну башкаруу элементтери (ойнотуу, тындыруу, токтотуу, артка түрүү, алдыга тез түрүү, өткөрүп жиберүү): Controls media playback on your DirecTV receiver.
• REC (Record): Учурдагы программаны жаздырууну баштайт.
• ЖЕТЕКЧЕ: Программанын жол көрсөткүчүн көрсөтөт.
• АКТИВДҮҮ: Accesses the DirecTV Active channel for interactive services.
• ТИЗМЕ: Жаздырылган программаларыңыздын тизмесин көрсөтөт.
• ЧЫГУУ: Учурдагы менюдан же экрандан чыгат.
• Back: Мурунку экранга же менюга кайтат.
• МЕНЮ: Accesses the main DirecTV menu.
• МААЛЫМАТ: Учурдагы программа тууралуу маалыматты көрсөтөт.
• SELECT (Center Button): Менюлардагы тандоолорду ырастайт.
• Жебе баскычтары: Менюлар жана каналдар аркылуу өтүңүз.
• VOL (+/-): Adjusts the volume of the programmed television.
• Үнсүз: Mutes the television audio.
• CHAN PAGE (Up/Down): Changes channels or pages through the guide.
• АЛДЫНДА: Мурункуга кайтат viewed каналы.
• Number Pad (0-9, DASH, ENTER): Түздөн-түз канал номерлерин киргизет.
• Түстүү баскычтар (кызыл, жашыл, сары, көк): Used for special functions within certain menus or applications.

IR vs. RF Mode

The RC66RX remote supports both Infrared (IR) and Radio Frequency (RF) modes. IR mode requires a direct line of sight between the remote and the device being controlled. RF mode uses radio waves, allowing you to control your DirecTV receiver without pointing the remote directly at it, even if the receiver is in a cabinet or another room (within range). Ensure your DirecTV receiver is RF-compatible for this feature to work.

Техникалык тейлөө

Батареяны алмаштыруу

When the remote's performance degrades or it stops responding, it is likely time to replace the batteries. Follow the battery installation steps in the Setup section to replace the two AA batteries.

Тазалоо

To clean your remote control, use a soft, dry cloth. For stubborn dirt, lightly dampкездемени суу же жумшак, абразивдүү эмес тазалоочу каражат менен сүртүңүз. Катуу химиялык заттарды же ашыкча нымдуулукту колдонуудан алыс болуңуз, анткени бул пульттун электроникасына зыян келтириши мүмкүн.

Проблемаларды чечүү

• Пульт жооп бербей жатат: Check if the batteries are correctly inserted and have sufficient charge. Replace batteries if necessary. Ensure the mode switch is set to the correct device (e.g., 'DIRECTV' for receiver functions).
• TV not responding to power/volume: Verify that the remote has been correctly programmed for your television using the IR programming steps. Ensure the mode switch is set to 'TV' when attempting to control TV functions.
• Buttons sticking or unresponsive: This may indicate dirt or debris under the buttons. Gently clean the remote as described in the Maintenance section. If the issue persists, the remote may need replacement.
• RF mode not working: Confirm your DirecTV receiver model is listed as RF compatible (R16, R22, H21, H22, H23, H24, HR21, HR22, HR23, HR24, HR34, C31). Ensure there are no major obstructions blocking the RF signal, although line-of-sight is not strictly required, extreme interference can affect performance.

Техникалык шарттар

Кепилдик жана колдоо

For warranty information and customer support, please refer to the documentation provided with your purchase or contact SatelliteSale customer service directly. Keep your proof of purchase for any warranty claims.