JEBAO TSP

Jebao TSP 30,000 Liter Adjustable Pond Pump User Manual

Model: TSP

1. Киришүү

This manual provides essential information for the safe and efficient operation of your Jebao TSP 30,000 Liter Adjustable Pond Pump. The TSP series models feature a powerful motor with innovative electronics, offering up to 65% energy savings. This pump is designed for use in pond filter and circulation systems, capable of handling dirt particles up to 6 mm in size. Its wear-resistant ceramic shaft ensures extended service life.

2. Коопсуздук нускамалары

  • Always disconnect the pump from the power supply before performing any maintenance, cleaning, or installation work.
  • Ensure the power cable and plug are undamaged. Do not operate the pump if the cable or plug is compromised.
  • The pump must be connected to a properly grounded electrical outlet.
  • Насосту кубат кабелинен кармап көтөрбөңүз же ташпаңыз.
  • Ensure the pump is installed in a stable position, either submerged or in a dry, protected area below water level.
  • Насосту иштетүү жана техникалык тейлөө учурунда балдарды жана үй жаныбарларын көлмө аймагынан алыс кармаңыз.
  • The pump is designed for water use only. Do not use it for other liquids.

3. Пакеттин мазмуну

Пакетте бардык буюмдар бар экенин текшериңиз:

  • Jebao TSP Pond Pump
  • Connection fittings (50 mm)
  • Электр кабели (10 м)
  • User Manual

4. Орнотуу жана орнотуу

The Jebao TSP pump is suitable for both submersible and dry installation. For dry installation, the pump is not self-priming and must be installed below the water level to ensure proper water flow to the pump inlet.

4.1. Submersible Installation

  1. Place the pump horizontally on a stable, flat surface at the bottom of the pond.
  2. Ensure the pump is fully submerged and free from obstructions.
  3. Connect the outlet hose (50 mm) to the pump's discharge port. Secure with a hose clamp зарыл болсо.

4.2. Dry Installation

  1. Install the pump in a dry, well-ventilated area, protected from direct sunlight and frost.
  2. The pump must be positioned below the water level of the pond to allow gravity-fed water supply.
  3. Connect the inlet hose (50 mm) from the pond to the pump's inlet port. Ensure a watertight seal.
  4. Connect the outlet hose (50 mm) to the pump's discharge port. Secure all connections.

4.3. Электр байланышы

After installation, connect the 10-meter power cable to a suitable, grounded electrical outlet. Ensure the outlet is protected by a Residual Current Device (RCD) for safety.

Jebao TSP Pond Pump main view

1-сүрөт: Негизги view of the Jebao TSP Pond Pump.

Jebao TSP Pond Pump dimensions diagram

Figure 2: Technical diagram showing the dimensions of the Jebao TSP Pond Pump (188 x 104 x 128 mm).

5. Иштөө нускамалары

Once the pump is correctly installed and connected to the power supply, it will begin operation. The TSP series pumps feature adjustable power consumption from 52 to 290 watts, allowing you to optimize flow rate and energy usage. Refer to any external controller provided with your pump for specific adjustment instructions.

5.1. Motor Protection

The pump is equipped with an electronic recognition IC that provides automatic 'dry-run' motor protection. If the rotor is blocked or the pump runs without water, the motor will automatically shut off to prevent damage. Disconnect power, inspect for blockages or lack of water, and then reconnect power to reset.

Jebao TSP Pond Pump performance curve graph

Figure 3: Performance curve illustrating flow rate (L/H) versus head height (M) for the Jebao TSP pump at different settings (e.g., 25000 L/H and 30000 L/H).

6. Техникалык тейлөө

Үзгүлтүксүз техникалык тейлөө насостун оптималдуу иштешин камсыз кылат жана анын иштөө мөөнөтүн узартат.

6.1. Cleaning the Impeller

  1. Насосту электр кубатынан ажыратыңыз.
  2. Remove the pump from the pond or disconnect it from the dry installation system.
  3. Carefully open the pump housing to access the impeller chamber.
  4. Remove any debris, algae, or blockages from the impeller and its chamber. A soft brush can be used.
  5. Inspect the ceramic shaft for wear or damage.
  6. Reassemble the pump, ensuring all seals are correctly seated.

6.2. Жалпы тазалоо

Periodically clean the exterior of the pump to prevent buildup of algae or mineral deposits. Use fresh water and a soft cloth. Do not use harsh chemicals or abrasive materials.

7. Кыйынчылыктарды

КөйгөйМүмкүн себепЧечим
Насос иштебейтЭлектр энергиясы жок
Импеллер бөгөттөлгөн
Dry-run protection activated
Check power connection and RCD
Clean impeller (see Section 6.1)
Ensure pump is submerged or receiving water, then reconnect power
Кыскартылган агымынын ылдамдыгыInlet/outlet blocked
Impeller dirty
Pump operating at low power setting
Check and clear blockages in hoses/fittings
Clean impeller (see Section 6.1)
Adjust power setting (if applicable)
Насос адаттан тыш үн чыгаратДөңгөлөктөгү сыныктар
Worn impeller or shaft
Clean impeller (see Section 6.1)
Тетиктерди алмаштыруу үчүн кардарларды колдоо бөлүмүнө кайрылыңыз

8. Техникалык шарттар

ӨзгөчөлүкСпецификация
МоделTSP
Энергияны керектөө52 - 290 Уоттс
Максималдуу агым ылдамдыгыСаатына 30,000 литр
Баштын максималдуу бийиктиги5 метр
Туташуу өлчөмү50 мм
Кабелдин узундугу10 метр
Өлчөмдөрү (L x W x Y)188 x 104 x 128 мм
Max. Debris Particle Size6 мм
Энергия булагыЭлектр зымдары
ӨндүрүүчүJEBAO
Биринчи жеткиликтүү күн21-февраль, 2020-жыл

9. Кепилдик жана колдоо

This product comes with an Italian warranty. For warranty claims, technical support, or replacement parts, please contact your retailer or the official Jebao distributor in your region. Ensure you have your proof of purchase and product model information available when contacting support.

© 2024 Jebao. All rights reserved.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.