BIG RED TAM825051 Torin Hydraulic Low Profile Trolley Floor Jack User Manual

Introduction

This manual provides essential instructions for the safe and effective use of your BIG RED TAM825051 Torin Hydraulic Low Profile Trolley Floor Jack. This hydraulic floor jack is designed for lifting vehicles with a maximum capacity of 2.5 tons (5,000 lb). It features a low-profile design, a single piston quick lift pump, and a safety bypass system to prevent overloading. Please read and understand all instructions and safety warnings before operation.

Коопсуздук маалыматы

WARNING: Failure to heed these warnings may result in personal injury and/or property damage.

• Always wear ANSI-approved safety goggles during setup and use.
• Do not exceed the rated capacity of 2.5 tons (5,000 lb).
• Катуу, түз жерде гана колдонуңуз.
• Immediately after lifting, support the vehicle with appropriate jack stands. Do not rely solely on the hydraulic jack for support.
• Do not use the jack for purposes other than lifting vehicles.
• Ensure the vehicle's parking brake is engaged and wheels are chocked before lifting.
• Keep hands and feet clear of the jack and vehicle during lifting and lowering.
• Домкрат гана таянып турган унаанын астында эч качан иштебеңиз.
• Do not modify the jack or use it with unauthorized attachments.

Пакеттин мазмуну

Чогултуудан жана иштетүүдөн мурун бардык компоненттердин бар экендигин текшериңиз:

• Гидравликалык полдун уячасы
• 2-Piece Handle
• Колдонуучунун Колдонмосу (бул документ)

Ассамблея

The BIG RED TAM825051 floor jack requires minimal assembly, primarily attaching the handle.

1. Insert the lower handle section into the handle socket on the jack.
2. Align the holes and secure the handle with the provided pin or screw, if applicable.
3. Attach the upper handle section to the lower section, ensuring it is firmly connected.

Once assembled, the handle is used for both pumping the jack and operating the release valve.

Орнотуу жана даярдоо

Before using the jack, perform the following steps:

1. Purge Air from Hydraulic System: Before first use, or if the jack has been stored for a long time, it may be necessary to purge air from the hydraulic system. To do this, open the release valve by turning the handle counter-clockwise. Pump the handle several times to remove any trapped air. Close the release valve by turning the handle clockwise.
2. Джекти текшериңиз: Check for any visible damage, leaks, or loose parts. Do not use the jack if it appears damaged.
3. Унааны даярдоо: Унааны катуу, тегиз жерге токтотуңуз. Кол тормозду басып, жерде кала турган дөңгөлөктөргө домпульстарды коюңуз.

Image: The BIG RED TAM825051 Torin Hydraulic Low Profile Trolley Floor Jack, showcasinанын компакттуу дизайны жана кызыл түстөгү жасалгасы.

Иштөө нускамалары

Унааны көтөрүү

1. Position the jack under the vehicle's designated lifting point. Refer to your vehicle's owner's manual for correct lifting points.
2. Ensure the saddle of the jack is centered and securely contacting the lifting point.
3. Close the release valve by turning the handle clockwise until it is firm. Do not overtighten.
4. Pump the handle up and down to raise the vehicle to the desired height.
5. Once the vehicle is lifted, immediately place appropriately rated jack stands under the vehicle's frame at the manufacturer's recommended support points.
6. Slowly lower the vehicle onto the jack stands by gently turning the release valve counter-clockwise. Ensure the vehicle is stable on the jack stands before performing any work.

Image: The red BIG RED floor jack positioned under the side of a red car, ready for lifting. This demonstrates proper placement for vehicle support.

Унааны түшүрүү

1. Raise the vehicle slightly off the jack stands using the hydraulic jack.
2. Домкрат таянычтарын унаанын астынан этияттык менен алып салыңыз.
3. Slowly turn the release valve counter-clockwise to gradually lower the vehicle to the ground. Control the lowering speed to prevent sudden drops.
4. Once the vehicle is fully lowered, remove the jack from under the vehicle.

Техникалык тейлөө

Гидравликалык домкраттын үзгүлтүксүз техникалык тейлөөсү анын узак мөөнөттүү иштешин жана коопсуз иштешин камсыздайт.

• Майлоо: Keep all moving parts of the jack well-lubricated. Apply light oil to pivot points and axles periodically.
• Гидравликалык суюктук: Check the hydraulic fluid level regularly. To check, fully lower the jack, remove the oil filler plug, and ensure the fluid is at the correct level. Use only high-quality hydraulic jack oil. Do not use brake fluid or motor oil.
• Тазалоо: Keep the jack clean from dirt, grease, and corrosive materials.
• Сактагыч: Store the jack in a fully lowered position in a clean, dry area.

Сүрөт: деталдуу view of the handle and release valve area of the BIG RED floor jack, highlighting key operational components.

Проблемаларды чечүү

If you encounter issues with your jack, refer to the following common problems and solutions:

Техникалык шарттар

• Модель номери: TAM825051
• Жүктөө жөндөмдүүлүгү: 2.5 tons (5,000 lb)
• Minimum Lifting Height: 3-3/8 inches (approximately 8.57 cm)
• Максималдуу көтөрүү бийиктиги: 14-15/16 inches (approximately 37.94 cm)
• Материал: Эритме болот
• Элемент Салмагы: 27.7 фунт (болжол менен 12.56 кг)
• Элементтин өлчөмдөрү (LxWxH): 24.5 x 10.3 x 5.7 дюйм (болжол менен 62.23 x 26.16 x 14.48 см)
• Унаа тейлөө түрү: Car (Note: Not recommended for all SUVs and trucks due to height limitations)

Image: A visual representation of the BIG RED floor jack, indicating its minimum height of 3-3/8 inches and maximum height of 14-15/16 inches.

Кепилдик жана колдоо

This BIG RED TAM825051 Torin Hydraulic Low Profile Trolley Floor Jack includes a limited 1-year manufacturer warranty. For warranty claims, technical support, or replacement parts, please contact BIG RED customer service. Keep your purchase receipt as proof of purchase.