Instruction Manual: Generic Replacement Igniter for Samsung NX58H5600SS and NX58H5650WS Range Ovens

1. Киришүү

This manual provides detailed instructions for the installation, operation, maintenance, and troubleshooting of the Generic Replacement Igniter for Samsung Range Ovens. This igniter is designed to restore proper heating function to compatible Samsung oven models.

2. Коопсуздук маалыматы

ЭСКЕРТҮҮ: Before attempting any installation or maintenance, ensure the oven's power supply is disconnected at the circuit breaker and the gas supply valve is turned off. Failure to do so can result in electric shock, gas leaks, fire, or serious personal injury.

If you are not comfortable performing this repair, it is recommended to contact a qualified appliance technician.

• Ар дайым кол кап жана коргоочу көз айнек сыяктуу тиешелүү жеке коргонуу шаймандарын тагыныңыз.
• Handle the igniter carefully; the ceramic element can be fragile.
• Ensure all connections are secure before restoring power and gas.

3. Продукт бүтүп калдыview

The Generic Replacement Igniter is a critical component in gas ovens, responsible for igniting the gas that heats the oven cavity. When activated, the igniter heats to a high temperature, allowing the gas valve to open and ignite the gas.

Сүрөт 1: Алдыңкы view of the Generic Replacement Igniter, showing the ceramic element and electrical connector.

Сүрөт 2: Бурчтуу view of the igniter, highlighting the internal heating element and protective casing.

Сүрөт 3: Каптал view of the igniter, showing the mounting bracket and ventilation slots on the metal casing.

4. Шайкеш моделдер

This replacement igniter is compatible with the following Samsung oven models:

• Samsung NX58H5600SS/AA-0000
• Samsung NX58H5650WS/AA-0000

Please verify your oven's model number before proceeding with installation.

5. Орнотуу (Орнотуу)

The following steps outline the general procedure for replacing the oven igniter. Specific oven designs may vary slightly.

1. Электр энергиясын жана газды өчүрүү: Turn off the electrical power to the oven at the circuit breaker and shut off the gas supply valve to the oven.
2. Мештин ички бөлүгүнө кирүү: Open the oven door. Remove any oven racks. Locate the bottom panel of the oven cavity. This panel is typically held by 2-4 screws. Remove these screws and lift out the bottom panel to expose the burner assembly.
3. От алдыргычты табыңыз: The igniter is usually located near the gas burner tube, often within a protective metal shield. It will have two wires connected to it.
4. Remove Heat Shields (if applicable): Depending on your model, you may need to remove additional heat shields or the burner bar itself. These are typically secured by 2-8 screws. Carefully lift the heating rod or burner assembly to gain full access to the igniter.
5. Зымдарды ажыратыңыз: You may need to remove the warming drawer (if present) to access the wiring harness underneath the oven. Disconnect the electrical connector for the old igniter. Note the routing of the wires.
6. Эски от алдыргычты алып салуу: The igniter is typically secured to its bracket with one or two screws. Remove these screws and carefully detach the old igniter.
7. Жаңы от алдыргычты орнотуу: Attach the new replacement igniter to the bracket using the screws removed in the previous step. Ensure it is securely fastened and positioned correctly.
8. Зымдарды кайра туташтыруу: Connect the new igniter's electrical connector to the oven's wiring harness. Ensure the connection is firm.
9. Духовканы кайра чогултуу: Carefully place the heating rod/burner assembly back into position. Reinstall any heat shields and the bottom oven panel. Replace the warming drawer if it was removed.
10. Электр энергиясын жана газды калыбына келтирүү: Turn on the gas supply valve and restore electrical power to the oven at the circuit breaker.
11. Сыноо операциясы: Set the oven to bake at a moderate temperature (e.g., 350°F). Observe the igniter. It should glow brightly within 30-60 seconds, and then the gas should ignite with a soft 'whoosh' sound.

6. Операция

Once installed, the igniter operates automatically as part of the oven's heating cycle. When the oven is set to a temperature, the control board sends power to the igniter. The igniter then heats up, drawing current. Once it reaches a sufficient temperature (typically 1800-2500°F), it allows the gas valve to open, and the hot igniter ignites the gas. The igniter continues to glow during the heating cycle to ensure consistent ignition.

7. Техникалык тейлөө

The igniter itself requires minimal maintenance. However, ensuring the oven cavity and burner area are kept clean can prolong the life of all components. Avoid spilling food or liquids directly onto the igniter or burner assembly.

8. Кыйынчылыктарды

If your oven is experiencing issues after igniter replacement or if you suspect a faulty igniter, consider the following:

• Oven Not Heating / No Gas Ignition: If the igniter does not glow when the oven is turned on, or glows dimly, it may be faulty or not receiving power. Check electrical connections.
• Slow Heating / Gas Smell: If the oven heats slowly, or you smell unburnt gas before ignition, the igniter may be weak. A weak igniter may not draw enough current to open the gas valve fully or quickly enough. This is a common symptom of a failing igniter.
• Loud Bang During Ignition: A loud 'THUMP' or 'BANG' during ignition can indicate a delayed ignition, often caused by a weak igniter that takes too long to heat up, allowing gas to accumulate before ignition.
• Igniter Lifespan: Replacement igniters typically have a lifespan of 1-2 years under normal use. If your igniter is within this timeframe and exhibiting symptoms, replacement may be necessary.

Always ensure power and gas are disconnected before inspecting internal components.

9. Техникалык шарттар

10. Кепилдик маалыматы

Specific warranty details for this Generic replacement part may vary depending on the retailer and purchase date. Please refer to your purchase documentation or contact the seller directly for information regarding warranty coverage and terms.

11. Колдоо

For technical assistance or further inquiries regarding this replacement igniter, please contact the seller or the manufacturer, SAN-SAN, through the contact information provided at the time of purchase. Always provide your product's ASIN (B0B52H7RG5) and your oven's full model number when seeking support.