MJX 7303 Hyper Go 1/7 RC Drift Car Instruction Manual

1. Киришүү

The MJX 7303 Hyper Go is a 1/7 scale brushless 4WD remote control drift car designed for rally racing enthusiasts. This manual provides essential information for setting up, operating, and maintaining your RC vehicle to ensure optimal performance and longevity.

2. Пакеттин мазмуну

Пакетиңизде бардык буюмдар бар экенин текшериңиз:

• MJX 7303 Hyper Go RC Drift Car (Ready-to-Go)
• Remote Controller
• Иштөө нускамалары (бул колдонмо)
• USB кабели
• One set of road tires (additional gift)

NOTE: Battery and charger are NOT included and must be prepared separately.

3. Орнотуу

3.1 Батареяны орнотуу

The MJX 7303 features an adjustable battery compartment to accommodate various battery sizes. Ensure your battery fits within the dimensions of approximately 14.5 cm x 5.2 cm.

1. Open the battery compartment cover on the chassis.
2. Insert your compatible battery, ensuring correct polarity.
3. Secure the battery and close the compartment cover.

3.2 Алыстан башкаруучуну орнотуу

The remote controller supports MODE1 and MODE2. Ensure batteries are installed in the remote controller (not included).

Familiarize yourself with the controller functions:

• CH1: ST (рулду башкаруу): Controls left and right movement.
• CH2: TH (дроссель): Controls forward and reverse speed.
• LED (Light Switch Control): Toggles the car's lights.
• ST.REV (Рулду тескери башкаруу): Reverses the steering direction.
• TH.TRIM (Throttle Neutral Adjustment): Adjusts the throttle's neutral position.
• ST.TRIM (Steering Trim): Adjusts the steering's center position.
• ST.D/R (Steering Dual Rate): Adjusts the maximum steering angle.
• TH.D/R (Throttle Dual Rate): Adjusts the maximum throttle output.
• Power Switch: Turns the remote controller on/off.

4. Иштөө нускамалары

4.1 First Run

1. Ensure the car's battery is fully charged and installed.
2. Turn on the remote controller first, then the car.
3. Wait for the car and controller to bind (indicator lights will confirm).
4. Test steering and throttle response at low speeds in a safe, open area.
5. Adjust ST.TRIM and TH.TRIM if the car does not drive straight or stops at neutral throttle.

4.2 Айдоо боюнча кеңештер

• The G3C Gyroscope assists in maintaining control during drifts and high-speed maneuvers. Experiment with its settings if adjustable.
• Utilize the 4WD system for excellent traction and control on various surfaces.
• The car is equipped with a full car linkage light set, which can be controlled via the LED switch on the remote.
• Practice gentle throttle and steering inputs to master drifting techniques.

5. Техникалык тейлөө

Regular maintenance will extend the life and performance of your RC car.

5.1 Жалпы кам көрүү

• Ар бир колдонгондон кийин, унааны кирди, чаңды жана таштандыларды кетирүү үчүн тазалаңыз.
• Inspect all screws and fasteners for tightness.
• Check for any damaged or worn parts.

5.2 Component Specific Maintenance

• Поезд: The car features metal CVDs, full car powder metallurgy gears, and three sealed metal differentials. Periodically inspect these components for wear and ensure they are free of obstructions.
• Токтотуу: The metal oil pressure shock absorbers should be checked for leaks and proper function. Ensure all full car bearings are clean and lubricated.
• Электроника: The receiver is housed in a waterproof box, providing protection from splashes. However, avoid submerging the car. Keep all electronic connections clean and dry.
• Шасси: The metal chassis and metal transmission shafts provide durability. Inspect for bends or damage after impacts.
• Шиналар: The car comes with two sets of tires. Use the appropriate set for your driving surface. Regularly check for wear and tear.

6. Кыйынчылыктарды

This section addresses common issues you might encounter with your RC car.

6.1 Car Not Responding

• Батареяны текшерүү: Ensure the car's battery is charged and properly connected.
• Remote Controller Power: Verify the remote controller has fresh batteries and is turned on.
• Байлоо: Confirm that the car and remote controller are properly bound. Turn both off, then turn on the controller first, followed by the car.
• Кубат өчүргүчтөр: Ensure both the car and controller power switches are in the 'ON' position.

6.2 Steering Problems

• Рулду башкаруу (ST.TRIM): Adjust the steering trim on the remote controller to center the wheels.
• Steering Reverse (ST.REV): If steering is reversed, use the ST.REV switch on the controller.
• тоскоолдуктар: Check for any debris or damage preventing the wheels from turning freely.
• Servo Function: Ensure the 35kg metal gear servo is functioning correctly and not jammed.

6.3 Motor/Throttle Issues

• Дроссель кесүү (TH.TRIM): Adjust the throttle trim if the car moves slightly when the throttle is neutral.
• ESC туташуу: Ensure the 120A Hall-effect brushless ESC is properly connected to the motor and receiver.
• Motor Inspection: Check the 3974 2500 KV brushless motor for any visible damage or debris.

7. Техникалык шарттар

8. Кепилдик жана колдоо

For specific warranty information and support, please refer to the seller's policies or contact the seller directly. General return and refund policies can be found via the seller's platform.

9. Колдонуучунун кеңештери

Берилген re'ден колдонуучунун конкреттүү кеңештери болгон жокviews or Q&A content. Always ensure your battery is fully charged before use for optimal performance and run time. Regularly clean your RC car, especially after driving in dusty or dirty conditions, to prevent wear on moving parts.