Westek TMDCD60 Hardwire Indoor Countdown 6-Setting Wall Switch Timer User Manual

Introduction

The Westek TMDCD60 is a hardwire indoor countdown timer designed to replace a standard wall switch. It provides timed control for lights, fans, heaters, and other devices, automatically turning them off after a selected duration. This manual provides instructions for safe installation, operation, and maintenance of your timer switch.

Коопсуздук маалыматы

ЭСКЕРТҮҮ: Электр шок коркунучу. Improper installation can lead to serious injury or death. Always turn off power at the circuit breaker or fuse box before beginning installation. Consult a qualified electrician if you are unsure about any part of the installation process.

• Бул аппарат имараттын ичинде гана колдонуу үчүн.
• Бардык зымдарды туташтыруу коопсуз жана жергиликтүү электр коддоруна ылайык экенин текшериңиз.
• Түзмөктүн электрдик кубаттуулук көрсөткүчтөрүнөн ашпаңыз.
• A neutral wire is required for installation. Older homes may not have a neutral wire in the switch box.

Пакеттин мазмуну

• Westek TMDCD60 Countdown Timer Switch
• Көрсөтмө (бул документ)

Продукт бүттүview

The Westek TMDCD60 timer switch features a single push-button control and LED indicators for selected time settings. It is designed to fit into a standard wall switch box and can be used with a standard rocker wallplate (not included).

Сүрөт 1: Алдыңкы view of the TMDCD60 timer switch. The face includes a single control button and five LED indicators labeled "10 MIN", "20 MIN", "30 MIN", "60 MIN", and "HOLD".

Орнотуу

1. Кубатты өчүрүү: Locate the circuit breaker or fuse that controls the switch you are replacing. Turn off the power completely before proceeding. Verify power is off using a voltage сыноочу.
2. Учурдагы которгучту алып салуу: Carefully remove the wallplate and unscrew the existing switch from the wall box. Disconnect the wires from the old switch. Note the connections for reference.
3. Зымдарды аныктоо: The Westek TMDCD60 timer requires four wires:
   • Кара зым: Hot (Line)
   • Кызыл зым: Load (to the device being controlled)
   • Ак зым: Нейтралдуу
   • Жашыл зым: Жер

   Ensure your wall box contains a neutral wire. If not, this timer cannot be installed without running a new neutral wire, which should be done by a qualified electrician.

   

   2-сүрөт: Артка view of the TMDCD60, illustrating the labeled wires for proper connection.
4. Зымдарды туташтыруу: Using wire nuts (not included), connect the wires from the wall box to the corresponding wires on the TMDCD60 timer switch:
   • туташтыруу Кара wire from the timer to the Hot (Line) wire from the wall box.
   • туташтыруу Кызыл wire from the timer to the Жүктөө wire from the wall box (to the light/fan).
   • туташтыруу Ак wire from the timer to the Нейтралдуу wire from the wall box.
   • туташтыруу Жашыл wire from the timer to the Жер wire from the wall box.
5. Таймерди орнотуу: Carefully fold the wires into the wall box. The timer is deeper than a standard switch, so ensure there is enough space. Secure the timer switch to the wall box using the provided screws.
6. Wallplate орнотуу: Attach a standard rocker wallplate (not included) over the timer switch.
7. Күчтү калыбына келтирүү: Электрди өчүргүчтөн же сактагыч кутудан кайра күйгүзүңүз.

Операция

The TMDCD60 timer operates with a single push-button control. Each press cycles through the available countdown settings and the HOLD function.

1. Turning On and Setting Timer: Press the control button once to activate the timer. The timer will cycle through the following settings with each subsequent press:
   • OFF (no LED lit)
   • 10 Minutes (10 MIN LED lights up)
   • 20 Minutes (20 MIN LED lights up)
   • 30 Minutes (30 MIN LED lights up)
   • 60 Minutes (60 MIN LED lights up)
   • HOLD (HOLD LED lights up)

   The connected device will remain on for the selected duration and then automatically turn off. The corresponding LED will indicate the active setting.

2. HOLD Функциясы: To keep the connected device on indefinitely, press and hold the control button for approximately one second until the "HOLD" LED illuminates. In HOLD mode, the device will remain on until you press the button again to turn it off or select a countdown setting.
3. Өчүрүү: To turn off the connected device before the countdown finishes or while in HOLD mode, press the control button until no LEDs are lit.

Техникалык тейлөө

The Westek TMDCD60 timer switch requires minimal maintenance. To clean the surface, wipe with a soft, damp кездеме. Абразивдүү тазалагычтарды же эриткичтерди колдонбоңуз. Тазалоодон мурун электр кубаты өчүрүлгөнүн текшериңиз.

Проблемаларды чечүү

Техникалык шарттар

• Модел: TMDCD60
• Бренд: Westek
• Түсү: Ак
• Киргизүү көлөмүtage: 120V AC, 60Гц
• Максималдуу жүк: 15A Resistive, 1000W Tungsten, 500VA Ballast, 1/4 HP Motor
• Таймердин жөндөөлөрү: 10, 20, 30, 60 minutes, HOLD
• Өлчөмдөрү: 1"D x 1"W x 1"H (Note: These dimensions typically refer to packaging; the device itself is deeper for in-wall installation.)
• Элемент Салмагы: 4.48 унция
• Монтаж түрү: Wall
• Которуу стили: Рокер которуу
• Нейтралдуу зым: Талап кылынат

Кепилдик жана колдоо

This Westek product is covered by a 1 жылдык чектелген кепилдик сатып алынган күндөн тартып. Бул кепилдик нормалдуу колдонуудагы материалдардагы жана жасалгадагы кемчиликтерди камтыйт.

For technical support or warranty claims, please contact Westek customer service. You can find more information and contact details on the official Westek webсайтка же баш багып Westek Store on Amazon.