Introduction
This manual provides detailed instructions for the safe installation, operation, and maintenance of your Leviton 15 Amp, 120 Volt, Duplex Style Combination Single Pole Switch/Receptacle, Model 5225. This device combines a single-pole switch and a 15 Amp, 125 Volt grounding receptacle in a single unit, designed for commercial and residential applications.
Коопсуздук маалыматы
ЭСКЕРТҮҮ: Өрттүн, токтун шок абалынын же өлүмдүн алдын алуу үчүн, зымдарды туташтыруудан мурун автоматтык өчүргүчтөгү же сактагыч кутучасындагы электр кубатын өчүрүп, электр кубатынын өчүк экенин текшериңиз. Бул түзмөк бардык улуттук жана жергиликтүү электр эрежелерине ылайык орнотулушу керек.
- Электр чынжырларында иштөөдөн мурун ар дайым электр кубатынан ажыратыңыз.
- Use only copper or copper-clad wire. Do not use aluminum wire with this device.
- Бардык зым байланыштары коопсуз экенин текшериңиз.
- Эгерде ушул көрсөтмөлөрдүн кайсы бир бөлүгүндө күмөн болсоңуз, квалификациялуу электрикке кайрылыңыз.
- Бул аппарат имараттын ичинде гана колдонуу үчүн.
Пакеттин мазмуну
- One Leviton 15 Amp, 120 Volt, Duplex Style Combination Single Pole Switch/Receptacle (Model 5225-W)
Орнотуу жана орнотуу
- Кубатты өчүрүү: Locate the circuit breaker or fuse that supplies power to the outlet box where you intend to install the device. Turn it OFF. Verify power is off using a voltage сыноочу.
- Remove Old Device (if applicable): Carefully remove the existing switch or receptacle from the wall box. Disconnect the wires, noting their connections.
- Зымдарды даярдоо: Strip approximately 1/2 inch (12.7 mm) of insulation from each wire end. Ensure wires are straight.
- Терминалдарды аныктоо: The Leviton 5225 device has the following terminals:
- Жашыл жер бурагы: For the bare copper or green insulated ground wire.
- Күмүш бурамалар: For neutral (white) wires.
- Жез бурамалар: For hot (black) wires.
- Break-off Tabs: Located on the side of the device, these tabs connect the switch and receptacle to the same hot feed. If you need to control the switch and receptacle from separate power sources, carefully break off the tab connecting the brass screws.
- Зым байланыштары:
Жер зымы: Connect the bare copper or green insulated ground wire from the wall box to the green ground screw on the device. Tighten securely.
Нейтралдуу зым: Connect the white neutral wire from the wall box to one of the silver screws. Tighten securely.
Hot Wire (Power In): Connect the black hot wire (power source) from the wall box to one of the brass screws. Tighten securely.
Load Wire (for Switch): If the switch controls a light fixture or other load, connect the load wire to the remaining brass screw. If the switch and receptacle are on the same circuit, and the break-off tab is intact, the switch will control the receptacle. If the tab is broken, the switch will control a separate load connected to its brass screw, and the receptacle will be constantly powered.
- Түзмөктү орнотуу: Carefully fold the wires into the wall box. Secure the device to the wall box using the provided mounting screws.
- Wallplate орнотуу: Attach a standard wallplate (not included) over the device.
- Күчтү калыбына келтирүү: Электрди өчүргүчтөн же сактагыч кутучасынан кайра күйгүзүңүз.
- Сыноо: Test the switch and receptacle functionality.
Сүрөт 1: Алдыңкы view of the Leviton 5225 combination switch and receptacle, showing the single pole switch at the top and the 15 Amp receptacle below.
2-сүрөт: Артка view of the Leviton 5225, illustrating the brass (hot), silver (neutral), and green (ground) wiring terminals, along with the break-off tab. The UPC 0078477965849 is visible.
Иштөө нускамалары
The single-pole switch operates by toggling the lever up or down to control the connected load. The 15 Amp receptacle functions as a standard electrical outlet for plugging in devices. If the break-off tab is intact, the switch will control power to the receptacle. If the tab is removed, the switch and receptacle operate independently.
Техникалык тейлөө
This device requires minimal maintenance. Periodically inspect the device and wallplate for any signs of damage or wear. Clean with a soft, dry cloth. Do not use abrasive cleaners or solvents.
Проблемаларды чечүү
- No Power to Receptacle/Switch: Check the circuit breaker or fuse. Ensure all wire connections are secure.
- Switch Not Controlling Receptacle: Verify that the break-off tab between the brass screws is intact if you intend for the switch to control the receptacle.
- Бошоң байланыштар: If the device feels loose in the wall box, ensure mounting screws are tightened.
Техникалык шарттар
| Өзгөчөлүк | Спецификация |
|---|---|
| Модель номери | 5225-Ж |
| Тtage | 120 вольт |
| Ampөчүрүү | 15 Amp (Switch), 15 Amp (Идишке) |
| Которуу түрү | Бир полюс |
| Чөйчөктүн түрү | Duplex Style, Grounding |
| Материал | Термопластикалык |
| Түс | Ак |
| Өлчөмдөр | 1.97 x 0.39 x 1.18 дюйм; 2.4 унция |
| Бекитүүлөр | UL 20, CSA C22.2 |
3-сүрөт: Каптал view of the Leviton 5225, showing approximate dimensions of 4.4 inches (11 cm) in length.
Кепилдик маалымат
Leviton provides a limited two-year warranty for this device. For specific details regarding warranty coverage and claims, please refer to the official Leviton webсайтка же кардарларды колдоо менен байланышыңыз.
Колдоо
For technical assistance, product information, or customer service, please visit the official Leviton website or contact their customer support department. You can find contact information and additional resources at www.leviton.com.
