1. Продукт бүтүп калдыview
The Sicce Ultrazero Flat Sucking Pump is designed for efficient removal of water from various areas, including flooded cellars, garages, and other spaces where minimal residual water is desired. This submersible pump is capable of reducing water levels down to 2-3 mm.
Негизги өзгөчөлүктөрү:
- Capable of pumping water down to 2 mm residual level.
- Fully submersible design.
- Handles dirt particles up to 3 mm in size.
- Equipped with a 10-meter power cable.
- Features a practical carry handle for easy transport.
Figure 1: ашыкview of the Sicce Ultrazero Flat Sucking Pump.
2. Коопсуздук маалыматы
Read all safety warnings and instructions before operating the pump. Failure to follow these instructions may result in electric shock, fire, or serious injury.
- Always disconnect the pump from the power supply before handling, cleaning, or performing any maintenance.
- электр менен жабдууну камсыз кылуу voltage matches the pump's specifications (230 V/50 Hz).
- Do not operate the pump with a damaged power cord or plug. If damaged, it must be replaced by the manufacturer, service agent, or similarly qualified persons to avoid a hazard.
- Do not use the pump to handle flammable or explosive liquids.
- Балдарды жана уруксаты жок адамдарды операциялык аймактан алыс кармаңыз.
- Ensure the pump is fully submerged during operation to prevent overheating.
- Avoid running the pump dry for extended periods.
- This pump is designed for water only. Do not use it for other liquids without consulting the manufacturer.
3. Орнотуу жана орнотуу
Follow these steps to properly set up your Ultrazero pump:
- Насосту таңгактан чыгаруу: Carefully remove the pump and all accessories from the packaging. Inspect for any damage.
- Connect the Discharge Hose:
The pump features a 26.44 mm (3/4") AG pressure connection. Attach a suitable discharge hose (e.g., 20 mm (3/4") hose connection) to this outlet. Ensure the connection is secure to prevent leaks.
Figure 2: Close-up of the pump's discharge outlet and integrated carry handle.
- Насосту жайгаштырыңыз: Place the pump directly on the surface from which water needs to be removed. Ensure the pump is stable and upright. The flat base allows for efficient water removal down to minimal levels.
- Route the Discharge Hose: Direct the discharge hose to a suitable drainage area, ensuring the water will not flow back into the area being drained.
- Кубат туташуу: Plug the 10-meter power cable into a grounded 230 V/50 Hz electrical outlet. Ensure the outlet is protected by a Ground Fault Circuit Interrupter (GFCI) for added safety, especially in wet environments.
Figure 3: The flat base of the pump designed for low residual water levels.
4. Иштөө нускамалары
The Ultrazero pump is designed for simple operation:
- Помпаны сууга чөктүрүңүз: Ensure the pump is fully submerged in the water you wish to remove. The pump requires water to cool its motor and operate correctly.
- насосту баштоо: Once submerged and connected to power, the pump will begin operating automatically. It does not feature a float switch, so manual monitoring is required for optimal use.
- Суунун деңгээлин көзөмөлдөө: The pump will continue to operate until the water level reaches its minimum suction capability of 2-3 mm.
- Соргучту токтотуу: To stop the pump, disconnect it from the power supply. It is recommended to disconnect the pump once the desired water level is reached or if the pump starts to run dry.
Figure 4: The Ultrazero pump effectively draining water from a small pool.
Figure 5: The pump in action on a flooded floor, demonstrating its low-level suction capability.
Figure 6: Illustration of the pump's ability to reduce water levels to approximately 2 mm.
5. Техникалык тейлөө
Үзгүлтүксүз техникалык тейлөө насосуңуздун узак мөөнөттүү иштешин жана оптималдуу иштешин камсыз кылат.
- Тазалоо: After each use, especially when pumping dirty water, rinse the pump thoroughly with clean water. This helps prevent sediment buildup.
- Таштандыларды текшерүү: Periodically check the pump's intake area for any debris (e.g., leaves, small stones) that might obstruct water flow. Remove any blockages carefully after disconnecting power.
- Кабелдик текшерүү: Regularly inspect the power cable for cuts, abrasions, or other damage. Do not use the pump if the cable is damaged.
- Сактагыч: When not in use, store the pump in a clean, dry place, protected from frost.
Figure 7: The pump can also be used for transferring water for tasks like garden watering from a rain barrel.
6. Кыйынчылыктарды
If you encounter issues with your Ultrazero pump, refer to the following common problems and solutions:
| Көйгөй | Мүмкүн себеп | Чечим |
|---|---|---|
| Насос иштебейт. | Электр энергиясы жок. Электр кабели бузулган. Мотордун ашыкча жүктөлүшүнөн коргоо иштетилген. | кубат туташуу жана розетка текшерүү. Inspect cable for damage; replace if necessary (by qualified personnel). Disconnect power, allow motor to cool, then reconnect. |
| Насос иштейт, бирок суу агып чыкпайт. | Intake blocked. Чыгаруучу түтүк бүктөлүп калган же тыгылып калган. Airlock in pump. | Disconnect power, clear intake. Check and clear discharge hose. Briefly lift and lower the pump while submerged to release trapped air. |
| Reduced pumping performance. | Partial blockage. Impeller worn. | Disconnect power, clean pump intake and impeller area. Тейлөө үчүн кардарларды колдоо кызматына кайрылыңыз. |
| Насос күтүлбөгөн жерден токтойт. | Overheating due to low water level or blockage. Электрдик ката. | Disconnect power, check water level and clear blockages. Allow to cool. Эгер көйгөй чечилбесе, кардарларды колдоо бөлүмүнө кайрылыңыз. |
If the problem persists after attempting these solutions, please contact Sicce customer support.
7. Техникалык шарттар
Detailed specifications for the Sicce Ultrazero Flat Sucking Pump, Model 925607:
| Спецификация | Нарк |
|---|---|
| Бренд | Сиксе |
| Модель номери | 925607 |
| Max. Delivery Rate (Flow Rate) | 3000 л/саат |
| Max. Жеткирүү бийиктиги | 3.1 м |
| Power Consumption (P1) | 80 Вт |
| Operating Voltage | 220-240 В / 50 Гц |
| Conductor Length (Power Cable) | 10 m (three-core, indoor and outdoor use) |
| Басым туташуу | 26.44 mm (3/4") AG |
| Шлангдын туташуу диаметри | 20 мм (3/4") |
| Max. Solids Size | 3 мм |
| Калган суунун деңгээли | Down to 2-3 mm |
| Продукциянын өлчөмдөрү (болжол менен) | 140 mm (Diameter) x 160 mm (Height) / 5.5" x 6.3" |
| Элемент Салмагы | 2.6 кг (5.72 фунт) |
| Float Switch | Жок |
| Ашыкча жүктөн коргоо | No (Internal thermal protection may exist, but no external reset) |
| Origin | Италияда жасалган |
Figure 8: Technical drawing illustrating the pump's dimensions and 3/4" GAS connection.
8. Кепилдик жана колдоо
For warranty information or technical support regarding your Sicce Ultrazero Flat Sucking Pump, please contact Sicce customer service. Keep your purchase receipt and model number (925607) handy when contacting support.
Өндүрүүчү: Эбара
Бренд: Сиксе
For further assistance, visit the official Sicce webсайтка кайрылыңыз же жергиликтүү дистрибьютериңиз менен байланышыңыз.
