1. Киришүү
This manual provides essential instructions for the safe and efficient use of your Claber Aquauno Programmer, model 53921 8425. This device is designed to automate garden watering by connecting directly to a tap, offering a simple and reliable solution for irrigation management.
Сүрөт 1: Алдыңкы view of the Claber Aquauno Programmer, showing the green START button, red STOP button, and the battery compartment cover.
2. Коопсуздук маалыматы
Please read and understand all safety warnings before operating the device. Failure to follow these instructions may result in damage to the product or personal injury.
- Суукка жол бербөө: Do not expose the programmer to temperatures below freezing. Remove the device from the tap and store it indoors during winter months to prevent damage.
- Балдар үчүн ылайыктуу эмес: Аппаратты балдар жетпеген жерде сактаңыз.
- Сыртта гана колдонуу: This programmer is designed exclusively for outdoor use.
- Бирок адамдарды сууга чөмүлдүртүү жок: The device is water-resistant but not submersible. Do not put it under water.
- Орнотуу орду: Do not install the programmer inside valve boxes or other enclosed spaces. It must be installed outdoors.
Image 2: Excerpt from the instruction sheet illustrating safety warnings and proper installation guidelines.
3. Пакеттин мазмуну
The Claber Aquauno Programmer package typically includes:
- 1 x Claber Aquauno Programmer (Model 53921 8425)
- 1 х Инструкция (бул документ)
Note: A 9V alkaline battery is required for operation and is not included.
4. Орнотуу
4.1. Батареяны орнотуу
- Open the battery compartment cover located at the bottom front of the programmer.
- Туура полярдуулукту камсыз кылуу үчүн жаңы 9V щелочтуу батарейканы салыңыз.
- Батарея уясынын капкагын бекем жабыңыз.
Image 3: Diagram from the instruction sheet illustrating the correct insertion of a 9V battery into the programmer's compartment.
4.2. Кранга бекитүү
- Ensure the tap is clean and free of debris.
- Screw the programmer directly onto a standard 3/4" outdoor tap. Hand-tighten only; do not overtighten.
- Connect your garden hose or irrigation system to the outlet of the programmer.
- Open the tap fully. The programmer is designed to operate under normal tap pressure.
Image 4: The programmer securely attached to an outdoor tap, with an irrigation hose connected to its outlet.
5. Орнотуу жана колдонуу боюнча нускамалар
The Claber Aquauno Programmer features a simple, one-program setup for daily automatic watering.
5.1. Programming the Watering Duration
- Кран ачык экенин текшериңиз.
- басыңыз green START button to begin watering. Water will start flowing.
- Allow the water to flow for the desired duration (minimum 1 minute, maximum 60 minutes).
- Once the desired watering time has passed, press the red STOP button. The water flow will cease.
- The programmer has now memorized this watering duration. It will automatically repeat this cycle once every 24 hours at the same time you pressed the green START button.
5.2. Manual Operation / Resetting the Program
- To manually start watering outside of the programmed cycle, simply press the green START button. Water will flow until you press the red STOP button. This manual operation does not affect the stored daily program.
- To reset the stored program and set a new watering duration, repeat the steps in section 5.1. The new duration will overwrite the previous one.
6. Техникалык тейлөө
6.1. Батареяны алмаштыруу
The programmer is powered by a 9V alkaline battery. When the battery level is low (approximately 8V), the device will automatically switch to a 48-hour watering cycle to conserve energy. Replace the battery as soon as possible to ensure continuous operation. Refer to section 4.1 for battery installation instructions.
6.2. Кышкы сактоо
Before the first frost, remove the programmer from the tap. Drain any remaining water and store the device in a dry, frost-free location indoors. Prolonged exposure to direct sunlight and extreme temperature fluctuations (especially freezing) can reduce the product's lifespan.
Image 5: Excerpt from the instruction sheet detailing battery replacement and recommendations for winter storage.
7. Кыйынчылыктарды
| Көйгөй | Мүмкүн себеп | Чечим |
|---|---|---|
| No water flow when START button is pressed. |
|
|
| Watering cycle occurs every 48 hours instead of 24 hours. | Батарея аз. | Replace the 9V alkaline battery immediately. |
| Incorrect watering duration. | Programmed duration was set incorrectly. | Repeat the programming steps (section 5.1) to set the desired duration. |
8. Техникалык шарттар
| Өзгөчөлүк | Деталь |
|---|---|
| Модель номери | 53921 (8425) |
| Бренд | Клабер |
| Power Source | 1 x 9V щелочтуу батарея (кошулбаган) |
| Сугаруу узактыгы | 1-60 мүнөт |
| Сугаруу жыштыгы | Every 24 hours (or 48 hours if battery is low) |
| Inlet Connection | 3/4" Tap Thread |
| Материал | Пластик |
| Элемент Салмагы | 371 грамм (болжол менен 13.1 унция) |
| Продукциянын өлчөмдөрү | Approx. 4.4 inches (11 cm) width. (Note: The provided product dimensions of 47.24"D x 70.87"W x 31.5"H appear to be incorrect for a tap timer. Please refer to the visual dimension guide or actual product for precise measurements.) |
| UPC | 800062528425 |
Image 6: Visual representation of the programmer's dimensions, indicating a width of approximately 4.4 inches (11 cm).
9. Кепилдик маалыматы
For detailed warranty information, please refer to the documentation included with your purchase or visit the official Claber webсайт. Кепилдиктин шарттары аймакка жана сатуучуга жараша өзгөрүшү мүмкүн.
10. Колдоо
For further assistance, product registration, or to download the latest version of this manual, please visit the official Claber webсайт: