1. Киришүү
This manual provides comprehensive instructions for the proper setup, operation, and maintenance of your Compustar 700R replacement remote for remote starter systems. Please read this manual thoroughly before attempting to use or program your new remote to ensure correct functionality and to avoid potential issues.
The Compustar 700R is designed as a direct replacement for compatible Compustar remote starter systems, offering reliable control over your vehicle's remote start, lock, unlock, and other auxiliary functions.
Image: The Compustar 700R replacement remote, a compact black device with multiple control buttons for vehicle functions.
2. Коопсуздук маалыматы
- Алыстан башкаруу пультун суудан жана ашыкча нымдуулуктан алыс кармаңыз.
- Avoid exposing the remote to extreme temperatures (hot or cold).
- Do not attempt to disassemble or modify the remote control. This may void the warranty and cause damage.
- Колдонулган батареяларды жергиликтүү эрежелерге ылайык жок кылыңыз. Батареяларды өрттөбөңүз.
- Батареяларды балдар жетпеген жерде сактаңыз. Эгер жутуп алса, дароо медициналык жардамга кайрылыңыз.
3. Пакеттин мазмуну
Пакетиңизде төмөнкү заттар бар экенин текшериңиз:
- Compustar 700R Replacement Remote (1 unit)
- Lithium Metal Battery (pre-installed or separate, typically 1 unit)
If any items are missing or damaged, please contact your retailer or Compustar support.
4. Орнотуу
4.1 Батареяны орнотуу
The Compustar 700R remote typically comes with a pre-installed battery. If you need to install or replace the battery, follow these steps:
- Пульттун артындагы батарея бөлүкчөсүнүн капкагын табыңыз.
- Carefully open the cover using a small coin or screwdriver if necessary.
- Insert the new Lithium Metal battery (e.g., CR2032) with the positive (+) side facing up, observing the polarity markings inside the compartment.
- Батарея уясынын капкагын бекем жабыңыз.
4.2 Programming the Remote
The 700R remote must be programmed to your vehicle's Compustar remote starter system to function. The programming procedure can vary slightly depending on your specific Compustar system and vehicle model. Always refer to your vehicle's remote starter system manual for the most accurate programming instructions. A common programming method involves the following general steps:
- Locate the Valet Switch: Find the Valet switch in your vehicle. This is usually a small button located near the steering column, under the dash, or in the fuse box area.
- Программалоо режимине кирүү:
- Insert your vehicle's key into the ignition.
- От алдыргычты ON абалына буруңуз (кыймылдаткычты иштетпеңиз).
- Within 5 seconds, press and release the Valet switch 5 times. The vehicle's parking lights should flash, or the horn may chirp, indicating entry into programming mode.
- Пультту программалоо:
- While the system is in programming mode, press and hold the Кулпу button (or the primary function button) on your new 700R remote for approximately 2 seconds.
- The vehicle's parking lights should flash again, or the horn may chirp, confirming that the remote has been programmed.
- Программалоо режиминен чыгуу: Turn the ignition OFF. The system will automatically exit programming mode after a few seconds of inactivity.
- Пультту текшерүү: Test all functions of the remote (lock, unlock, remote start) to ensure successful programming.
Эскертүү: If you are programming multiple remotes, program them one after another without exiting programming mode. If an existing remote stops working after programming a new one, you may need to re-program all remotes simultaneously.
5. Иштөө
The Compustar 700R remote provides control over various vehicle functions. Button labels and functions may vary slightly based on your specific Compustar system configuration.
- Кулпу баскычы: Press once to lock the vehicle doors.
- Кулпуну ачуу баскычы: Press once to unlock the vehicle doors.
- Алыстан баштоо баскычы: Press and hold for approximately 2-3 seconds to initiate remote engine start. The vehicle's parking lights will flash, and the engine will start.
- Remote Stop Button: While the engine is running via remote start, press and hold the Remote Start button again for 2-3 seconds to turn off the engine.
- Trunk Release / Auxiliary Button: Press and hold for approximately 2-3 seconds to open the trunk or activate a programmed auxiliary function (e.g., power sliding doors).
- Panic / Car Finder Button: Press and hold for approximately 2-3 seconds to activate the vehicle's alarm (panic mode) or to locate your vehicle in a parking lot (car finder). Press any button to deactivate.
Refer to your Compustar system's main user manual for detailed information on specific button combinations and advanced features.
6. Техникалык тейлөө
6.1 Батареяны алмаштыруу
When the remote's range decreases or it becomes unresponsive, it may be time to replace the battery. Follow the steps outlined in Section 4.1 Battery Installation. The 700R remote uses one Lithium Metal battery (e.g., CR2032).
6.2 Тазалоо
To clean the remote, wipe it gently with a soft, dry cloth. Do not use harsh chemicals, abrasive cleaners, or immerse the remote in water.
6.3 Сактоо
Пультту узак убакыт бою колдонбогондо, түз күндүн нурунан жана экстремалдык температурадан алыс, салкын, кургак жерде сактаңыз.
7. Кыйынчылыктарды
| Көйгөй | Мүмкүн себеп | Чечим |
|---|---|---|
| Remote not responding / No functions work | Өлгөн же аз батарея Пульт диапазондон тышкары Алыстан башкаруу программаланган эмес |
Батареяны алмаштыруу (4.1-бөлүм) Унаага жакыныраак жылыңыз Re-program the remote (Section 4.2) |
| Кыска иштөө диапазону | Батарея аз Курчап турган чөйрөнүн кийлигишүүсү Obstructions between remote and vehicle |
Батареяны алмаштыруу (4.1-бөлүм) Move away from sources of interference (e.g., power lines, large metal structures) Ensure clear line of sight if possible |
| Унаа алыстан от албайт | Vehicle conditions not met (e.g., hood open, door ajar, low fuel) Remote not programmed correctly |
Check vehicle status indicators Ensure vehicle is in 'ready mode' for remote start Re-program the remote (Section 4.2) |
| Existing remote stopped working after programming new one | System exited programming mode before all remotes were programmed | Re-program all remotes (old and new) in a single programming session (Section 4.2) |
If you continue to experience issues after attempting these troubleshooting steps, please contact Compustar customer support or an authorized dealer.
8. Техникалык шарттар
- Модел: 700R
- Элемент Салмагы: 0.96 унция
- Пакеттин өлчөмдөрү: 4.65 x 2.72 x 0.59 дюйм
- Батареялар: 1 Литий Металл батарейкасы талап кылынат (кошулган)
- Өндүрүүчү бөлүгүнүн номери: 700R
- Өзгөчө өзгөчөлүгү: Эргономикалык дизайн
- Байланыш технологиясы: Infrared (Note: Some Compustar systems use RF, verify compatibility with your system)
- Түсү: Кара
9. Кепилдик жана колдоо
For detailed warranty information regarding your Compustar 700R replacement remote, please refer to the official Compustar website or the warranty card included with your original remote starter system. Warranty terms typically cover manufacturing defects for a specified period from the date of purchase.
If you require technical assistance, have questions about programming, or need to report a defect, please contact Compustar customer support through their official website or consult an authorized Compustar dealer. Providing your product model (700R) and any relevant system information will help expedite support.
Онлайн ресурстар: Visit the official Compustar webКөп берилүүчү суроолор, жаңыртылган колдонмолор жана колдоо байланыш маалыматы үчүн сайт.
