Introduction
This manual provides essential instructions for the safe and effective use, setup, operation, and maintenance of your Graco 17P483 Edge II Plus HVLP Spray Gun. Please read this manual thoroughly before operating the equipment to ensure optimal performance and safety.
Image: A silver and blue Graco Edge II Plus HVLP spray gun with a black handle and a clear 32 oz Flexliner cup attached to the bottom.
Жайгашуу
1. Attaching the Fluid Cup
The Graco Edge II Plus gun is designed for use with a 32 oz. Flexliner cup, which is included. Ensure the cup is securely attached to the gun's fluid inlet. The Quick Release Fluid Set allows for easy attachment and detachment.
2. Аба менен камсыздоону туташтыруу
Connect your air supply hose to the gun's air inlet. The gun is air-powered and requires a suitable air compressor. Ensure all connections are tight to prevent air leaks.
3. Alternative Fluid Supply
The gun includes different fittings to accommodate various fluid supply options. If using a turbine cup or a pressure cup system, remove the standard fitting and install the appropriate fitting provided with the gun. Refer to the specific instructions for your alternative fluid supply system for proper connection.
Иштөө нускамалары
1. Fluid Level Adjustment
The Edge II Plus gun features a dial for precise fluid level adjustment. Rotate the dial located near the trigger to control the amount of fluid being sprayed. Start with a lower setting and gradually increase until the desired flow is achieved.
2. Fan Pattern Adjustment
Adjust the spray fan pattern by rotating the air cap at the front of the gun. This allows you to switch between horizontal, vertical, and circular spray patterns to suit your application needs. Experiment with different settings on a test surface to find the optimal pattern.
3. Триггер операциясы
Depress the trigger to begin spraying. Release the trigger to stop. Maintain a consistent distance and speed from the surface for an even finish.
Техникалык тейлөө
Regular cleaning and maintenance are crucial for the longevity and performance of your spray gun.
1. Колдонгондон кийин тазалоо
After each use, thoroughly clean the gun. Disassemble the fluid cup and air cap. Flush the gun with an appropriate cleaning solution (water for latex paints, solvent for oil-based paints) until all paint residue is removed. Clean the fluid passages, air cap, and fluid tip.
2. Needle and Fluid Set Replacement
The Edge II Plus gun is designed for quick and easy needle and fluid set replacement. To replace, twist off the front section of the gun, push the release mechanism, and pull out the needle. Insert the new needle and reassemble. This process typically takes less than a minute.
3. Сактоо
Store the clean and dry spray gun in a safe place, protected from dust and extreme temperatures.
Проблемаларды чечүү
If you encounter issues with your Graco Edge II Plus spray gun, consider the following common solutions:
- Начар чачыратуу схемасы: Check for clogs in the fluid tip or air cap. Ensure the air cap is correctly aligned and tightened. Adjust fluid and air pressure settings.
- No Fluid Flow: Verify the fluid cup contains material and is properly sealed. Check for blockages in the fluid line or tip. Ensure the needle is not stuck.
- агып жатат: Inspect all connections for tightness. Check seals and O-rings for damage or wear.
- Ыйгарымсыз басым: Ensure your air compressor is providing a consistent air supply at the recommended pressure.
For persistent issues, contact Graco customer support or a qualified service technician.
Техникалык шарттар
| Өзгөчөлүк | Деталь |
|---|---|
| Бренд | Graco |
| Модель номери | 17P483 |
| Танк көлөмү | 0.25 Gallons (32 oz. Flexliner Cup) |
| Түс | Көп түстүү |
| Сунушталган Колдонуулар | Сүрөт тартуу |
| Материал | Plastic (handle, cup), Metal (gun body) |
| Стиль | Gun |
| Power Source | Air Powered |
| Камтылган компоненттер | 1 qt FlexLiner Cup, #3 Quick Release Fluid Set, 1 x Pump Gun |
| Максималдуу басым | чарчы дюймуна 50 фунт |
| UPC | 755652419259 |
| Пакеттин өлчөмдөрү | 12.5 x 9 x 6 дюйм |
| Элемент Салмагы | 3 фунт |
Кепилдик маалымат
For detailed warranty information regarding your Graco 17P483 Edge II Plus HVLP Spray Gun, please refer to the documentation included with your purchase or visit the official Graco webсайт. Кепилдиктин шарттары жана шарттары аймакка жана продуктуга жараша өзгөрүшү мүмкүн.
Колдоо
If you require technical assistance, replacement parts, or have questions not covered in this manual, please contact Graco customer support. Contact information can typically be found on the Graco webсайтында же продуктунун таңгагында.
- Онлайн ресурстар: Расмий Graco сайтына баш багыңыз webКөп берилүүчү суроолор, өнүмдөрдү каттоо жана кошумча колдоо материалдары үчүн сайт.
- Кардарларды тейлөө: Refer to your product packaging or the Graco website for current customer service contact numbers and hours of operation.
