Introduction
This manual provides essential information for the installation, operation, and maintenance of your new Gladiator Premium Starter. This starter is designed to meet or exceed OEM specifications, ensuring reliable performance for compatible Ford New Holland TS Series Tractors with Iveco Engines, including models TS90, TS100, TS110, TS115, TS6.100, TS6.120, TS6.125, and TS6.140, as well as various Case Ag Tractor and New Holland Industrial Ag Tractor models. It is a 12 Volt, 3.0KW, 10-tooth unit, 100% computer load tested for reliability.
For a comprehensive list of compatible models, please refer to the specifications section or the product description.
Коопсуздук маалыматы
Always prioritize safety when working with automotive components. Failure to follow these guidelines may result in injury or damage to equipment.
- Disconnect the battery's negative terminal before beginning any work on the electrical system.
- Тиешелүү жеке коргоочу шаймандарды (ЖКК), анын ичинде коопсуздук көз айнектерин жана кол каптарды кийиңиз.
- Ensure the vehicle is stable and properly supported before working underneath it.
- Refer to the vehicle's service manual for specific instructions and torque specifications.
- Keep all tools and work areas clean and organized.
- If unsure about any procedure, consult a qualified mechanic.
Орнотуу жана орнотуу
Proper installation is crucial for the optimal performance and longevity of your new starter. These are general guidelines; always consult your vehicle's specific service manual.
- Даярдоо: Ensure the vehicle's ignition is off and the parking brake is engaged. Disconnect the negative battery cable.
- Эски башталгычты табыңыз: Identify the existing starter motor, typically mounted on the engine block near the flywheel or transmission bell housing.
- Зымдарды ажыратыңыз: Carefully disconnect all electrical connections from the old starter, noting their positions for reinstallation. This usually includes a large battery cable and a smaller solenoid wire.
- Бекитүүчү болтторду алып салыңыз: Unbolt the old starter from the engine block. Be prepared for the starter to be heavy.
- Жаңы башталгычты орнотуу: Position the new Gladiator Premium Starter in place and secure it with the mounting bolts. Ensure proper alignment.
- Зымдарды кайра туташтыруу: Reattach all electrical connections to the new starter, ensuring they are tight and secure.
- Батареяны кайра туташтыруу: Терс батарея кабелин кайра туташтырыңыз.
- Сыноо: Attempt to start the engine to confirm proper operation. Listen for unusual noises.
Сүрөт 1: Алдыңкы view of the Gladiator Premium Starter, showing the main body and solenoid. This image highlights the robust construction and primary components of the starter motor.
2-сүрөт: View of the Gladiator Premium Starter's pinion gear. This gear engages with the engine's flywheel to crank the engine during startup.
Иштөө принциптери
The starter motor is an electric motor that rotates the engine's flywheel to initiate the combustion process. When the ignition key is turned to the "start" position, electrical current flows from the battery to the starter solenoid. The solenoid then engages the starter's pinion gear with the engine's flywheel and simultaneously sends power to the starter motor. The motor spins the flywheel, cranking the engine until it starts. Once the engine begins to run, the solenoid disengages the pinion gear from the flywheel to prevent damage.
This Gladiator Premium Starter is designed for 12-volt systems and provides 3.0 kilowatts of power, ensuring sufficient cranking power for compatible diesel engines.
Техникалык тейлөө
Starters are generally low-maintenance components. However, regular checks of the associated electrical system can prolong its life and ensure reliable starting.
- Батареянын ден соолугу: Ensure your vehicle's battery is fully charged and in good condition. A weak battery can overwork the starter.
- Кабелдик байланыштар: Periodically inspect battery cables and starter connections for corrosion or looseness. Clean and tighten as necessary.
- Жер байланыштары: Verify that all ground connections are clean and secure.
- Ашыкча кычкылдануудан алыс болуңуз: Do not crank the engine for more than 10-15 seconds at a time. Allow the starter to cool for a minute or two between attempts to prevent overheating.
Проблемаларды чечүү
Эгерде сиз стартериңиз менен көйгөйлөргө туш болсоңуз, төмөнкү кеңири таралган көйгөйлөрдү жана чечимдерди карап көрүңүз:
| Симптом | Мүмкүн себеп | Чечим |
|---|---|---|
| Engine does not crank or cranks slowly | Weak or dead battery; Loose or corroded battery cables/connections; Faulty starter solenoid; Faulty starter motor. | Батареянын көлөмүн текшериңизtage and charge/replace if necessary; Clean and tighten all connections; Test solenoid and starter motor. |
| Clicking sound when trying to start | Батареянын көлөмү азtage; Faulty starter solenoid. | Charge or replace battery; Test and replace solenoid if needed. |
| Стартер айланат, бирок кыймылдаткыч иштебейт | Faulty starter drive (bendix) or pinion gear. | Replace the starter motor. |
| Burning smell or smoke from starter | Overheated starter due to excessive cranking or internal short. | Allow starter to cool; Check for shorts; Replace starter if damage is evident. |
| Starter remains engaged after engine starts | Faulty solenoid or ignition switch. | Immediately turn off engine; Test and replace solenoid or ignition switch. |
| Стартер майдалоочу үн чыгарат | Damaged flywheel teeth or starter pinion gear. | Inspect flywheel and starter gear; Replace damaged components. |
| Starter works intermittently | Loose connections; Intermittent solenoid fault; Worn brushes inside starter. | Check and secure all connections; Test solenoid; Consider starter replacement. |
| Starter draws excessive current (drains battery quickly) | Internal short in starter motor. | Replace starter motor. |
| Starter does not engage with flywheel | Faulty solenoid (not pushing pinion out); Damaged pinion gear or drive. | Test solenoid; Inspect and replace starter if pinion or drive is damaged. |
Техникалык шарттар
Key specifications for the Gladiator Premium Starter:
| Өзгөчөлүк | Деталь |
|---|---|
| Бренд | Гладиатор |
| Модель номери | � 504357110 |
| Тtage | 12 вольт |
| Ватtage | 𠃣 KW |
| Pinion Teeth | 10 Тиш |
| Элемент Салмагы | � pounds (288 Ounces) |
| Продукциянын өлчөмдөрү (L x W x Y) | �.5 x 7 x 4.5 inches |
| Материал | Металл |
| OEM мүнөздөмөлөрү | OEM мүнөздөмөлөрүнө жооп берет же андан ашат |
| Сыноо | Компьютердин 100% жүктөмү ишенимдүүлүк үчүн текшерилген |
| Шайкеш бөлүктүн номерлери | 0001262022, 19980N, 0-001-262-021, 0-001-262-022, 00012620213Z2 |
Шайкештик: This starter is compatible with a wide range of Case Ag Tractor and New Holland Tractor models. Please verify fitment with your specific vehicle's requirements. Examples камтыйт:
- Case Ag Tractor: Farmall 85C, 95C, 95N; Maxxum 100, 110, 115, 120, 130; MXU100, MXU110, MXU115.
- New Holland Ind Ag Tractor: T4040, T4050, T6.120, T6.140, T6.150, T6.175, T7.170, T7.220, T7.260, T7.270, T7.230, TD5.105, TD5.95, TS6.120.
- New Holland Tractor: TS100, TS110, TS110A, TS115A, TS6.100, TS6.120, TS6.125, TS6.140, TS90, TT60A.
Кепилдик жана колдоо
The Gladiator Premium Starter comes with a Бир жылдык кепилдик сатып алынган күндөн тартып. Бул кепилдик нормалдуу колдонууда жана тейлөөдө материалдардагы жана жасалгадагы кемчиликтерди камтыйт.
For warranty claims, technical support, or any questions regarding your product, please contact the seller or manufacturer directly through the platform where the purchase was made. Please have your purchase details and model number ready.
For additional resources, you may refer to the official Gladiator webсайт же ыйгарым укуктуу тейлөө борборлору.
