AIRTOK аба тазалагыч AP1002 алмаштыруучу чыпкасынын колдонуу боюнча колдонмосу

Introduction

This instruction manual provides essential information for the proper installation, operation, and maintenance of your AIRTOK Air Purifier AP1002 Replacement Filter (Model AP1002-RF). This H13 True HEPA filter is designed to maintain the optimal performance of your AIRTOK AP1002 air purifier, ensuring clean and healthy air in your environment.

Негизги өзгөчөлүктөрү

• Authentic AIRTOK Filters: Designed specifically for the AIRTOK AP1002 air purifier (AP1002-RF) to ensure consistent, reliable performance and prevent damage to the appliance.
• H13 True HEPA Technology: Capable of removing up to 99.97% of airborne particles as small as 0.1 microns, including pet dander, plant pollen, smoke, fibers, dust, and various odors.
• Properly Sealed: Filters are sealed to protect their lifespan. It is crucial to remove the plastic packaging before installation.
• Easy to Replace: Features a convenient 3-in-1 design for straightforward replacement.
• Узак өмүрү: Recommended replacement every 3-6 months, depending on usage frequency and air quality conditions.

Орнотуу жана орнотуу

Follow these steps to install your new AIRTOK AP1002 Replacement Filter:

1. Ensure the AIRTOK AP1002 air purifier is powered off and unplugged from the electrical outlet.
2. Locate the filter compartment on your air purifier. Refer to your air purifier's main instruction manual for specific access details.
3. Remove the old filter. Dispose of the used filter responsibly.
4. Unwrap the new AP1002-RF filter from its plastic packaging. Failure to remove plastic packaging will prevent the filter from functioning correctly.
5. Insert the new filter into the air purifier's filter compartment, ensuring it is seated correctly.
6. Фильтр бөлүктүн капкагын бекем жабыңыз.
7. Plug the air purifier back into the electrical outlet and power it on.

Operating Instructions (Filter Reset)

After replacing the filter, you must reset the filter replacement indicator on your AIRTOK AP1002 air purifier:

1. With the new filter installed and the air purifier powered on, locate the filter replacement indicator button.
2. Press and hold the filter replacement indicator button for approximately 3-5 seconds.
3. You should hear a beep, and the indicator light will turn off, confirming the reset.

Техникалык тейлөө

To ensure continuous optimal performance of your AIRTOK air purifier, regular filter replacement is essential:

• Фильтрди 3-6 ай сайын алмаштыруу сунушталат.
• The actual replacement interval may vary based on the frequency of air purifier use and the level of air pollution in your environment. In highly polluted areas or with continuous use, more frequent replacement may be necessary.
• The air purifier's filter replacement indicator will illuminate after approximately 1,500 hours of continuous operation to remind you to change the filter.

Проблемаларды чечүү

Filter Replacement Indicator Remains On After Changing Filter

If the filter replacement indicator light continues to blink or remain on after you have installed a new filter, it may not have been reset correctly. Please follow the operating instructions above to reset the filter indicator by pressing and holding the designated button for 3-5 seconds until a beep is heard and the light turns off.

Продукт спецификациялары

Продукт медиасы

Сүрөттөр

Расмий продукт Videos

Кепилдик жана колдоо

For warranty information, technical support, or any inquiries regarding your AIRTOK Air Purifier AP1002 Replacement Filter, please refer to the original air purifier's user manual or contact AIRTOK customer service directly. Contact details are typically available on the manufacturer's official webсайтында же продуктунун таңгагында.