1. Киришүү
The ChiliTec 23522 foot dimmer switch is designed for stepless brightness control of compatible lighting fixtures. This versatile device supports dimmable LED lamps ranging from 3-100W and traditional incandescent or halogen lamps from 75-300W. It features a robust, non-slip plastic housing and is intended for indoor use only. The dimmer offers two distinct outputs: one for dimmable lighting (0-100% adjustable) and a separate ON/OFF switch for non-dimmable applications, such as reading lamps.
2. Коопсуздук нускамалары
Орнотуудан жана колдонуудан мурун ушул коопсуздук көрсөтмөлөрүн кунт коюп окуп чыгыңыз. Бул көрсөтмөлөрдү аткарбоо электр тогуна урунууга, өрткө же башка коркунучтарга алып келиши мүмкүн.
- Үй ичинде гана колдонуу: This device is rated IP20 and is suitable for dry indoor environments only. Do not expose to moisture or water.
- Электр коопсуздугу: Installation must be performed by a qualified electrician or a person with appropriate electrical knowledge, in accordance with local wiring regulations.
- Электр энергиясын өчүрүү: Орнотуу, зымдарды орнотуу же техникалык тейлөө иштерин жүргүзүүдөн мурун ар дайым электр кубатынан ажыратыңыз.
- Жүктөө шайкештиги: Ensure that the connected lamps are within the specified wattage range (3-100W for dimmable LEDs, 75-300W for incandescent/halogen) and are explicitly marked as dimmable.
- Туура зымдар: Pay close attention to correct polarity (Live, Neutral) and ensure the Protective Earth (PE) conductor is properly connected for Class 1 luminaires.
- Страховка: The device contains an internal, replaceable 2A/250V fuse. Only replace with a fuse of the same type and rating.
- Зыян: Эгер аппарат бузулуп калса, аны колдонбоңуз.
3. Пакеттин мазмуну
- 1x ChiliTec 23522 Foot Dimmer Switch
4. Техникалык шарттар
| Type | Phase-cut dimmer with switch |
| Материал | Plastic (durable, non-slip) |
| Түс | Кара |
| Operating Voltage | 230V / 50Hz |
| Max. Dimmable Load | 300 Вт |
| Жылытуу/Галоген Lamp Шайкештик | 75-300W |
| Жарыктандыруучу LED Lamp Шайкештик | 3-100W |
| Туташуу түрү | 6-pole terminal strip (screw terminals) |
| Min. Wire Cross-section | 3x 1.0 мм² |
| Max. Cable Outer Diameter | 6.5мм |
| Ички Fuse | 2A / 250V (replaceable) |
| Өлчөмдөр (WxLxH) | Болжол менен. 103x60x32mm |
| Коргоо классы | IP20 |
| Өзгөчөлүктөрү | Slider for dimming, ON/OFF switch, orientation light, strain relief |
5. Орнотуу жана орнотуу
Before proceeding with installation, ensure the main power supply is disconnected at the circuit breaker.
- Турак жайды ачуу: Carefully open the dimmer housing. This typically involves unscrewing the housing screws located on the underside.
- Ички View:
Ички view of the ChiliTec 23522 foot dimmer switch with the top cover removed. The image displays the green 6-pole screw terminal block for wiring connections, the dimmer circuit board, and the internal components including the fuse and inductor.
- Зымдар диаграммасы: Refer to the wiring diagram below for correct connections.
Wiring diagram for the ChiliTec 23522 foot dimmer switch. This schematic illustrates the connections for two outputs: one dimmable (L/N/PE) and one switched (L/N), along with the input power (L/N/PE) and internal components like the slider, switch, and fuse.
- Киргизүү кубаттуулугун туташтыруу: Connect the main power supply cable (230V/50Hz) to the designated input terminals (L/N/PE) on the 6-pole terminal strip. Ensure Live (L), Neutral (N), and Protective Earth (PE) are correctly matched. The Protective Earth connection is essential for Class 1 luminaires.
- Connect Output 1 (Dimmable): Connect the cable for your dimmable lamp to the first output terminals (L/N/PE). This output is controlled by the slider for dimming.
- Connect Output 2 (Switched): Connect the cable for your non-dimmable lamp (e.g., a reading lamp) to the second output terminals (L/N). This output is controlled by the separate ON/OFF button.
- Коопсуз зымдар: Ensure all wires are securely fastened in the screw terminals. The minimum wire cross-section is 3x 1.0 mm², and the outer diameter of the connecting cables should not exceed 6.5mm.
- Чыңалуудан арылтуу үчүн каражатты орнотуу: Properly install the strain relief mechanisms for all connected cables to prevent accidental pulling or damage to the connections.
- Жабык турак жай: Carefully close the dimmer housing and secure it with the screws.
- Күчтү калыбына келтирүү: Орнотуу аяктагандан жана текшерилгенден кийин, чынжырга электр кубатын кайтарыңыз.
6. Иштөө нускамалары
The ChiliTec 23522 foot dimmer switch offers intuitive control over your lighting.
ChiliTec 23522 foot dimmer switch, top-down view.
ChiliTec 23522 foot dimmer switch, angled top view.
- Dimmable Output Control: Use the prominent slider control to adjust the brightness of the connected dimmable lamp. Sliding it from one end to the other will smoothly vary the light output from 0% (off) to 100% (full brightness).
- Switched Output Control: The separate square button acts as an ON/OFF switch for the second, non-dimmable output. Press the button to toggle the connected lamp күйгүзүү же өчүрүү.
- Orientation Light: The dimmer features an orientation light, which may illuminate to help locate the switch in the dark.
7. Техникалык тейлөө
- Тазалоо: To clean the dimmer, wipe the exterior with a dry, soft cloth. Do not use abrasive cleaners, solvents, or wet cloths, as this may damage the device or pose an electrical hazard.
- Сактагычты алмаштыруу: The dimmer contains an internal 2A/250V fuse. If the dimmer stops functioning, the fuse may need replacement. Disconnect power before opening the housing and replace the fuse with one of identical type and rating (2A/250V).
- Текшерүү: Periodically inspect the cables and housing for any signs of wear or damage. If damage is found, discontinue use and have the device inspected by a qualified professional.
8. Кыйынчылыктарды
If you encounter issues with your ChiliTec 23522 dimmer, refer to the following common troubleshooting steps:
- Жарык күйбөйт:
- Негизги электр булагы туташып жана активдүү экендигин текшериңиз.
- Бардык зымдардын туташууларынын бекем жана схемага ылайык туура экенин текшериңиз.
- туташканын текшериңизamp is functional and properly installed.
- Check the internal 2A/250V fuse and replace if blown (see Maintenance section).
- Light Not Dimming or Flickering:
- Confirm that the connected lamp is explicitly marked as dimmable. Not all LED lampлар күңүрт болуп саналат.
- l камсыз кылууampватtage is within the specified range for the dimmer (3-100W for LEDs, 75-300W for incandescent/halogen).
- Бошогон зым байланыштарын текшериңиз.
- Эгерде LED lamps, some LED types may exhibit minor flickering at very low dimming levels due to compatibility.
- No Power to Switched Output:
- Ensure the ON/OFF button is pressed to the 'ON' position.
- Verify wiring connections for the second output.
Бул кадамдарды жасагандан кийин көйгөй чечилбесе, кардарларды колдоо менен байланышыңыз.
9. Кепилдик маалыматы
This ChiliTec product is covered by a standard manufacturer's warranty. The specific terms and duration of the warranty may vary based on your region and point of purchase. Please retain your proof of purchase for any warranty claims. For detailed information regarding your warranty, refer to the documentation provided at the time of purchase or contact your retailer.
10. Колдоо
Should you require technical assistance, have questions about installation, or need further support regarding your ChiliTec 23522 foot dimmer switch, please contact:
- ChiliTec Customer Service: Refer to the contact information provided on the product packaging or the official ChiliTec webсайт.
- Сиздин сатуучуңуз: The store or online platform where you purchased the product can often provide direct support or guide you to the appropriate service channels.
