Introduction
This manual provides comprehensive instructions for the installation, operation, and maintenance of your Weiser Prague Matte Black Passage Door Knob. This non-locking knob is designed for interior doors such as those for hallways and closets, where no locking mechanism is required. The sleek matte black finish and contemporary design enhance any home interior.
Кутуда эмне бар
- 1 эшик туткаларынын топтому (ички жана тышкы)
- 1 Бекитүүчү
- 1 Strike Plate
- Монтаждоо бурамалар
- Орнотуу боюнча колдонмо
Керектүү куралдар
- Phillips Head Screwdriver (#2 recommended)
Орнотуу нускамалары
Follow these steps for proper installation of your Weiser Prague Passage Door Knob. For visual guidance, refer to the product overview video below.
Видео: Продукция бүттүview - Demonstrates components and assembly process.
- Эшик даярдоо жана өлчөмдөрүн текшерүү:
Ensure your door meets the following specifications: door thickness 1-3/8" to 1-3/4" (35mm-44mm); Latch Backset 2-3/8" (60mm) or 2-3/4" (70mm); Cross Bore 2-1/8" (54mm). If drilling a new door, use the supplied template and complete door drilling instructions.
Image: Weiser Prague Matte Black Passage Door Knob, front view.
- Adjust the Backset of the Latch (if needed):
Hold the latch in front of the door hole with the latch face flush against the door edge. If the latch holes are centered in the door hole, no adjustment is required. If not centered, adjust the latch by moving the pin to extend the latch.
Image: All components of the door knob laid out, including the latch, knobs, and screws.
- Latch орнотуу:
Insert the latch into the door edge. Secure it with the provided screws. Ensure the slant bolt faces the door frame when the door is closed.
- Орнотуу баскычтары:
Press the latch bolt to install the exterior knob. Remove the interior knob. Loosen the pre-installed set screw on the interior knob base. Place the knob base on the center point and secure with screws. Push up on the knob base while tightening screws to keep the latch horizontal and centered. Install the interior knob and tighten the set screw.
Image: The matte black door knob installed on a white door, with a clear view of the latch mechanism on the door edge.
- Install Strike Plate on Door Frame:
Install the strike plate on the door frame using the provided screws. Close the door and test the latch operation. If the latch is loose in the strike, adjust the strike tab so it grips the latch bolt better when the door is closed.
Image: An exploded diagram showing the individual components of the door knob and their assembly order.
Иштөө нускамалары
The Weiser Prague Passage Door Knob is a non-locking mechanism. To open the door, simply turn the knob in either direction. The latch will retract, allowing the door to open. To close, push the door shut, and the latch will automatically engage with the strike plate, holding the door in place.
Техникалык тейлөө
To maintain the finish and functionality of your door knob, follow these guidelines:
- жумшак менен үзгүлтүксүз тазалоо, гamp кездеме. Абразивдүү тазалагычтардан, эриткичтерден же катуу химиялык заттардан алыс болуңуз, алар финишке зыян келтириши мүмкүн.
- Do not use furniture polish or other household cleaners on the door knob.
- Periodically check and tighten any loose mounting screws to ensure secure operation.
Проблемаларды чечүү
If you encounter any issues with your door knob, consider the following common solutions:
- Knob is Loose: Check if the mounting screws are securely tightened. If the interior knob is loose, ensure the set screw (if applicable for your specific variant) is tightened.
- Latch Not Engaging Properly: Verify that the strike plate on the door frame is aligned correctly with the latch bolt. The strike tab can be adjusted to provide a better grip if the latch is loose.
- Катуу операция: Ensure all components are installed without excessive force or misalignment. A small amount of silicone-based lubricant can be applied to the latch mechanism if needed, but avoid over-lubricating.
Техникалык шарттар
| Өзгөчөлүк | Деталь |
|---|---|
| Өндүрүүчү | Weiser |
| Бөлүмдүн номери | 9GA1010-154 |
| Продукциянын өлчөмдөрү | 6.67 x 6.19 x 6.19 см |
| Элемент Салмагы | 744 г |
| Өлчөмү | баскыч |
| Түс | Matte Black |
| Стиль | Passage (Non-locking) |
| Бүтүрүү | Powder капталган |
| Материал | Металл |
| Форма | Тегерек |
| Эшиктин калыңдыгынын шайкештиги | 1-3/8" - 1-3/4" |
| Latch Backset | 2-3/8" - 2-3/4" |
| Кайчылаш бургулоо | 2-1/8" |
| Өзгөчөлүктөр | Орнотуу оңой |
Кепилдик
This Weiser Prague Passage Door Knob comes with a Чектелген өмүр бою механикалык жана бүтүрүү кепилдик. For specific terms and conditions, please refer to the warranty information provided with your product packaging or contact Weiser customer support.
Колдоо
For further assistance, technical support, or to inquire about replacement parts, please visit the official Weiser webсайтка же кардарларды тейлөө бөлүмүнө кайрылыңыз. Байланыш маалыматы, адатта, продуктунун таңгагынан же бренддин расмий өкүлүнөн тапса болот webсайт.
