Introduction
This user manual provides comprehensive instructions for the installation, operation, and maintenance of your InSinkErator FHC3010 Modern Hot and Cold Water Dispenser. Please read this manual thoroughly before installation and use to ensure safe and efficient operation of your appliance. Keep this manual for future reference.
Продукт бүттүview
The InSinkErator FHC3010 is a modern hot and cold water dispenser designed for convenience and efficiency in your kitchen. It provides instant access to near-boiling water and filtered cold water directly from your sink.
Figure 1: InSinkErator FHC3010 Hot and Cold Water Dispenser in Matte Black finish.
Негизги өзгөчөлүктөрү:
- Modern design with Matte Black finish.
- Dedicated faucet for instant hot and cold water.
- Provides near-boiling water (up to 200°F) for hot beverages and cooking.
- Delivers filtered cold water.
- Easy-to-use dual handles for precise temperature control.
- Under-sink installation for a clean countertop appearance.
Жайгашуу
Proper installation is crucial for the performance and safety of your water dispenser. It is recommended that installation be performed by a qualified plumber.
Баштоодон мурун:
- Ensure you have all necessary tools and components as listed in the packaging.
- Verify that your electrical outlet meets the product's power requirements (Corded Electric).
- Confirm adequate space under the sink for the dispenser tank and connections.
- Ашкана раковинасына негизги суу менен камсыздоону өчүрүңүз.
Орнотуу кадамдары:
- Раковина тешигин даярдаңыз: If a hole is not pre-drilled, create a 1-3/8 inch (3.5 cm) diameter hole in your sink or countertop.
- Кранды орнотуу: Insert the faucet shank through the sink hole. Secure it from underneath with the provided mounting hardware.
- Суу линияларын туташтыруу: Connect the hot and cold water supply lines to the appropriate inlets on the dispenser faucet. Ensure all connections are tight to prevent leaks.
- Танкты орнотуу: Position the hot water tank securely under the sink. Connect the tank's outlet to the faucet's hot water inlet.
- Электр байланышы: Plug the dispenser's power cord into a grounded electrical outlet.
- Системаны жуу: Before heating, open the hot water handle on the dispenser and allow water to flow until it runs smoothly, removing any air from the system.
- Жылуулукту иштетүү: Once flushed, turn on the power to the hot water tank. Allow approximately 15-20 minutes for the water to reach its set temperature.
Иштөө нускамалары
Your InSinkErator FHC3010 dispenser is designed for simple and intuitive operation.
Ысык сууну берүү:
- Locate the hot water handle (typically on the left side).
- Push the handle back and hold it to dispense near-boiling water. Release the handle to stop the flow.
- Абайлаңыз: Hot water can cause burns. Always use care when dispensing hot water.
Муздак суу берүү:
- Locate the cold water handle (typically on the right side).
- Pull the handle forward and hold it to dispense filtered cold water. Release the handle to stop the flow.
Техникалык тейлөө
Regular maintenance ensures the longevity and optimal performance of your dispenser.
Тазалоо:
- Крандын сыртын жумшак, гamp cloth and mild soap. Avoid abrasive cleaners or harsh chemicals.
- For the Matte Black finish, use non-abrasive cleaning products specifically designed for matte surfaces to prevent damage.
Фильтрди алмаштыруу:
- The water filter (if installed) should be replaced every 6 months or as indicated by reduced water flow.
- Refer to your filter's specific instructions for replacement procedures.
Descaling (for Hot Water Tank):
- In areas with hard water, mineral deposits may accumulate in the hot water tank.
- Consult a qualified technician for descaling procedures if you notice a significant decrease in hot water flow or temperature.
Проблемаларды чечүү
Эгерде сиз диспенсериңиз менен көйгөйлөргө туш болсоңуз, төмөнкү кеңири таралган көйгөйлөрдү жана чечимдерди караңыз:
| Көйгөй | Мүмкүн себеп | Чечим |
|---|---|---|
| Ысык суу жок | Power not connected or tripped breaker. Tank not filled. | Check power connection and circuit breaker. Ensure water flows from the hot side before turning on power. |
| Суунун аз агымы | Clogged filter. Kinked water line. | Replace water filter. Check water lines for kinks or obstructions. |
| Leaking from faucet | Loose connections. Damaged O-rings. | Tighten connections. Contact customer support for replacement parts or service. |
| Суу жетиштүү ысык эмес | Temperature setting too low. Mineral buildup. | Adjust temperature setting on the tank (if applicable). Consider descaling. |
If the problem persists, please contact InSinkErator customer support.
Техникалык шарттар
| Атрибут | Деталь |
|---|---|
| Бренд | InSinkErator |
| Модель номери | 45394Y-ISE (FHC3010) |
| Түс | Matte Black |
| Стиль | Заманбап |
| Орнотуу түрү | Раковинанын астында |
| Орнотуулардын саны | 2 (Ысык, Муздак) |
| Жогорку температура рейтинги | 200 градус Фаренгейт |
| Power Source | Электр зымдары |
| Продукциянын өлчөмдөрү | 5.21 x 6 x 9 дюйм |
| Элемент Салмагы | 4.3 фунт |
Кепилдик жана колдоо
InSinkErator products are built with quality and durability in mind. For specific warranty information, please refer to the warranty card included with your product or visit the official InSinkErator website. For technical support, replacement parts, or service inquiries, please contact InSinkErator customer service.
Көбүрөөк маалымат жана байланыш маалыматтарын даректен таба аласыз Amazonдагы InSinkErator дүкөнү.
